What did you do to your OBS GMT400 Tahoe/Yukon Today?

[96ProCompTahoe]

have one of these threads on another forum I frequent (s10forum) and its always pretty entertaining.


SO what did YOU do to your 'HOE/'KON TODAY?!




Pulled the rest of the parts off the engine to get the lower intake off so it can go to the shop tomorrow to get cleaned. intake was FULL of crud and was expecting under the valve covers to be just as bad but to my suprise they were CLEAN! didn't get any pictures of it today as the camera was in the house and i was covered with oily crud. have some from most of the tear down yesterday that i'll throw up sometime this week probably when the trucks done.

 

[BillBlatt18]

there is one of these threads in the 00-06 forum

 

[Ceejkay]

i washed mine, even though it has not been drove in 2 weeks....

 

[Trippers99hoe]

I just looked at mine in the driveway........it has been 100+ degrees every day for like 60 days in a row.My list of things to do has grown all summer.

 

['93Yuke]

I installed an OEM antenna and full antenna cable, and replaced a dash panel below my steering column, and did another small repair on my drivers door panel.. I also partially cleaned it out.. then went out and did a little hill climbing

 

[96ProCompTahoe]

Just got word that the machine shop didn't get all the crud out of the lower intake and want it for another day . looks like the reassembly will have to wait another day.

 

[SunlitComet]

 

[AtomicHoe094]

there is one of these threads in the 00-06 forum

But this is the 94 to 00 section duhh!! geez those nbs people haha


nothing today on my truck, but 2 days ago i was bolting on the whipple

 

[SunlitComet]

 

[AtomicHoe094]

ill make a new thread shortly. lost my camera 2 hrs before the install. FML.. lol

 

[DefendHawaii]

Waxed my hood because it was heavily oxidized. Looks great! also did a light coat to the rest of the vehicle and looking a the roof I am going to have to make a call and get the entire vehicle professionally detailed because I am gonna be to busy to do the roof etc before the fall.

 

[gregsb]

I broke down and did a tune up last night on mine. I figured that even though I don't have a lot of miles on my truck I do have a lot of years and a tuneup could not hurt. It did wake it up a little bit.

Taking advice that I found here I did all ACDelco components, plugs, wires, distributor cap and rotor.

All I can say is I am glad that these vortec engines don't require annual tuneups because getting to a few of the plugs on a lifted truck is a pain. I remember on my '74 K5 I used to just climb into the engine bay to do it but there was a lot more room and a lot less of me then http://www.tahoeyukonforum.com/forum/images/smilies/smile.gif

I don't know how you guys with big lifts do it as my 4" made it difficult enough.

 

[bowtiefreak]

I'm going to take the cover off it and drive it until I get the burban inspected. That's about it for now. Clean it most likely also

 

[retorq]

Rehooked up my amp and speaker box, took them out while moving. And I jammed to Godsmack and 5FDP on the way to work.

---------- Post added at 09:51 AM ---------- Previous post was at 09:23 AM ----------

Ohh I did a new rear cover too, got one of those Summit ones with the load studs for the caps and new axle seals. Drivers side was trashed, the brakes need to be take off and thoroughly cleaned. I will look at a disc swap soon.

 

[AtomicHoe094]

shit you should of told me retorq, i needa sell mine and get the slim cover one so it wont hit the sway bar :doh:

 

[retorq]

shit you should of told me retorq, i needa sell mine and get the slim cover one so it wont hit the sway bar :doh:

... well dang ...

 

[AtomicHoe094]

yea a little late now. lol how you like the pan otherwise?

 

[EvilCaprice]

I just looked at mine in the driveway........it has been 100+ degrees every day for like 60 days in a row.My list of things to do has grown all summer.

This...

 

[BillBlatt18]

But this is the 94 to 00 section duhh!! geez those nbs people haha


nothing today on my truck, but 2 days ago i was bolting on the whipple

well geez lol. Everyone posts in the nbs section one. But who cares haha. Geez, OBS people...

 

[bowtiefreak]

Adam, pics and price to me for the cover please