Bose speaker replacement

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

jay-rod427

TYF Newbie
Joined
Jan 17, 2020
Posts
6
Reaction score
1
I have been lurking here for a while, and searched through tons of posts, but haven't found anything definitive.

Does anyone have a recommended speaker to replace the door speakers. 2013 yukon denali. They are blown. I have an aftermarket h/u but don't really want to get an amp, and rewire all the speakers and all that.

BUT I believe the bose speakers are an uncommon impedance, and replacing them with aftermarket while still using the bose amp system will cause issues.

Thanks in advance for any recommendations.
 

Big Mama

Full Access Member
Joined
Jul 21, 2015
Posts
3,881
Reaction score
2,499
Location
Virginia
Welcome from Virginia Jay. I’m no audio guru but some will chime in soon. Did they recently blow or it happened when the new HU was put in? If they were good for a while why not go back with the same thing?
 

Doubeleive

Wes
Supporting Member
Joined
Nov 7, 2017
Posts
30,584
Reaction score
48,091
Location
Stockton, Ca.
I would just buy some good used oem bose speakers off of ebay or the junk yard then.
 
OP
OP
J

jay-rod427

TYF Newbie
Joined
Jan 17, 2020
Posts
6
Reaction score
1
Welcome from Virginia Jay. I’m no audio guru but some will chime in soon. Did they recently blow or it happened when the new HU was put in? If they were good for a while why not go back with the same thing?

Thanks for the welcome!

Well I've owned it about 6 months, and they have slowly degraded to crackling and distorting once the volume gets to about 20 on my alpine h/u. The head unit went in about 4 months ago. Really it's the rear door speakers that are the worst, but i figure if I'm gonna tear it apart to do all 4 of the door speakers. My eventual plan and main reason for keeping the bose amp is keeping the stock 6.5" sub for mid base as I think it sounds pretty decent, and then supplementing it with a 10-12" in a custom box between the 2nd row captain chairs. The stock sub can help bridge the gap from the door mids to the low freq 10".

I can either keep or replace the pillar tweeters, but they are fine as is so hoping to get a component speaker for the front doors, and possibly coax for the rear doors. Whatever works in those places without volume differences due to off impedences.

Also I'd be totally fine with replacing them with stock replacements if their reasonably priced and easy to get. Don't really want used salvage yard speakers.
 

Joseph Garcia

Elite Member
Supporting Member
Joined
Aug 2, 2018
Posts
10,351
Reaction score
15,007
Welcome to the Forum from NH, Jay.

Lots of great folks here, who freely share their experiences and make suggestions/recommendations to other folks questions. Lurking is OK, but contributing is better for everyone. :)

If I understand you correctly, you have an aftermarket head unit, which you have connected to the low level inputs of the existing OEM Bose power amp. Is that correct? You are correct that Bose speakers have a different impedance (~2 ohms) than most aftermarket speakers (4 ohms).

Regarding you plans to install a sub between the second row captain's chairs, that is exactly what I did. I had a custom, downward-firing sealed box fabricated, and I installed a 10" AudioMobile sub in it. You cannot hear me coming 2 blocks away (which is perfectly fine with me), but the sound inside the truck is loud, tight and clean. See the photo below, and the dog hair is from one of my 90+lb white shepherds, who likes to sit on the sub box, looking over my shoulder, as we cruise down the road. It also serves as a table for folks sitting in the second row, though I rarely have more than 2 people and 2 dogs in the truck on any trip.

I also removed the entire Bose system, as I prefer a different sound than what Bose delivers. I believe that I still have the 4 door and 2 post Bose speakers, and as I recall, they all worked, prior to me removing them. You can have them for free, if you are willing to pay postage. If you wish to pursue this, contact me through a 'Conversation' in this Forum's apps, and I'll go find them.

Subwoofer.jpg
 
Last edited:
OP
OP
J

jay-rod427

TYF Newbie
Joined
Jan 17, 2020
Posts
6
Reaction score
1
Welcome to the Forum from NH, Jay.

Lots of great folks here, who freely share their experiences and make suggestions/recommendations to other folks questions. Lurking is OK, but contributing is better for everyone. :)

If I understand you correctly, you have an aftermarket head unit, which you have connected to the low level inputs of the existing OEM Bose power amp. Is that correct? You are correct that Bose speakers have a different impedance (~2 ohms) than most aftermarket speakers (4 ohms).

Regarding you plans to install a sub between the second row captain's chairs, that is exactly what I did. I had a custom, downward-firing sealed box fabricated, and I installed a 10" AudioMobile sub in it. You cannot hear me coming 2 blocks away (which is perfectly fine with me), but the sound inside the truck is loud, tight and clean. See the photo below, and the dog hair is from one of my 90+lb white shepherds, who likes to sit on the sub box, looking over my shoulder, as we cruise down the road. It also serves as a table for folks sitting in the second row, though I rarely have more than 2 people and 2 dogs in the truck on any trip.

I also removed the entire Bose system, as I prefer a different sound than what Bose delivers. I believe that I still have the 4 door and 2 post Bose speakers, and as I recall, they all worked, prior to me removing them. You can have them for free, if you are willing to pay postage. If you wish to pursue this, contact me through a 'Conversation' in this Forum's apps, and I'll go find them.

View attachment 238642

View attachment 238643

View attachment 238642

Yes Alpine touchscreen using metra harness and maestro kept all stock features intact. That is AWESOME on the sub. Yes I'm going to build a custom enclosure, and prob be a bit taller than yours with the top fitting between the arm rests, and incorporate some cup holders since the fold down ones will be blocked. Ultimately it will look similar to the front row console. Leather wrapped and all, finding a matching fabric will be tough. Cocoa/cashmere interior here.

I will def hit you up for your speakers:cool:. In the end enough people will probably convince me to go aftermarket speakers and amp for all but the sub...
 

swathdiver

Full Access Member
Joined
May 18, 2017
Posts
21,301
Reaction score
30,257
Location
Treasure Coast, Florida
I have been lurking here for a while, and searched through tons of posts, but haven't found anything definitive.

Does anyone have a recommended speaker to replace the door speakers. 2013 yukon denali. They are blown. I have an aftermarket h/u but don't really want to get an amp, and rewire all the speakers and all that.

BUT I believe the bose speakers are an uncommon impedance, and replacing them with aftermarket while still using the bose amp system will cause issues.

Thanks in advance for any recommendations.

Amazon still sells all of them last time I checked. Plug your VIN in here and have a look: https://parts-catalog.acdelco.com/catalog/catalog_search.php

I believe the front door speakers are 15905042 and the rear door speakers are 15186669. They are uncommon as we've talked about on here before many times.
 
OP
OP
J

jay-rod427

TYF Newbie
Joined
Jan 17, 2020
Posts
6
Reaction score
1
Amazon still sells all of them last time I checked. Plug your VIN in here and have a look: https://parts-catalog.acdelco.com/catalog/catalog_search.php

I believe the front door speakers are 15905042 and the rear door speakers are 15186669. They are uncommon as we've talked about on here before many times.

Thank you for that. 15905042, and 23418091. $200 for a new set isn't bad at all. Will probably take up @Joseph Garcia on his used set and see how that goes. Worst case get all 4 new and hopefully not blow them again for a while. I don't particularly blast the stereo too loud, but obviously blew the stockers sometime between when I got the truck and now tho.
 

swathdiver

Full Access Member
Joined
May 18, 2017
Posts
21,301
Reaction score
30,257
Location
Treasure Coast, Florida
Thank you for that. 15905042, and 23418091. $200 for a new set isn't bad at all. Will probably take up @Joseph Garcia on his used set and see how that goes. Worst case get all 4 new and hopefully not blow them again for a while. I don't particularly blast the stereo too loud, but obviously blew the stockers sometime between when I got the truck and now tho.

With the factory amps, the louder you turn it up, the more bass they pull to protect the speakers. Just saw Joe's post, definitely take him up on that offer! He's a good man.
 
OP
OP
J

jay-rod427

TYF Newbie
Joined
Jan 17, 2020
Posts
6
Reaction score
1
BTW I just now put 2+2 together. I think the rear ones shot craps first because right after I bought it and drove in rain realized both rear doors were sloshing with water, and thanks to this site learned to cleanout the holes in the bottom of the door(plugged with crud). And as low as the speakers are probably got wet and finished off what I assume are paper cones, or fried them playing when they were wet.
 

Geoffsfas10

Full Access Member
Joined
Nov 27, 2019
Posts
806
Reaction score
1,761
Location
St. Louis
I had the infinity kappas in my old Sierra that had the bose, they are a 2ohm speaker. They sounded great with an aftermarket headunit, super loud and clear. When I put the stock headunit back in for various reasons ( when first one was stolen, when i traded in truck ) they sounded even better with the factory one. Sounded just as good as my aftermarket with a 10" sub. I know infinity isnt the most expensive or probably even the best anymore but I certainly liked them
 

kbuskill

***CAUTION*** I do my own stunts!
Joined
Mar 11, 2017
Posts
5,825
Reaction score
9,836
Location
NE. FL.
I have been lurking here for a while, and searched through tons of posts, but haven't found anything definitive.

Does anyone have a recommended speaker to replace the door speakers. 2013 yukon denali. They are blown. I have an aftermarket h/u but don't really want to get an amp, and rewire all the speakers and all that.

BUT I believe the bose speakers are an uncommon impedance, and replacing them with aftermarket while still using the bose amp system will cause issues.

Thanks in advance for any recommendations.

Here is some good info I posted about the Bose speakers ...

https://www.tahoeyukonforum.com/threads/bose-speakers.101909/page-5#post-1228439

Hope that helps.

I also went with Infinity speakers with the Bose amp and Kenwood HU it sounds great. I also have a down firing box between the 2nd row buckets. 12" Kicker Comp pushed by a Hi Fonics Brutus 600w mono block.
 

nsticka

TYF Newbie
Joined
Mar 10, 2019
Posts
8
Reaction score
2
I had to pull the rear door panel off to replace the door handle and the rear speaker was listed as 3.8 ohms. I have 12 denali.

I wanted to replace speakers but with everything I read, speakers are fine its the amp and sub that needs upgraded.

any suggestions on amp? I want a little more clarity and a touch more bass.

I am thinking of replacing center dash speaker and the speakers in A pillar as well.
 
OP
OP
J

jay-rod427

TYF Newbie
Joined
Jan 17, 2020
Posts
6
Reaction score
1
awesome @Joseph Garcia is gonna send me his old stockers. hopefully that will suffice and help fight off the urge to spend a bunch of money and replace the whole system with aftermarket.
 

Forum statistics

Threads
137,817
Posts
1,992,838
Members
102,795
Latest member
Drewphil
Back
Top