Fless
Latest activity Postings About
-
-
Fless replied to the thread Changed thermostat, Coolant temperature stays at 185 degrees.If the shaft is driven by the water pump, it's a clutch fan (one). The electric fans are dual and are not connected to the water pump. -
Fless reacted to BigRed300r's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with
Like.
Today I finally finished putting my 04 Tahoe z71 back together. It all started with a plugged drain for the rear a/c. Flooded the carpet... -
I had the pleasure of helping a fellow member reset his crankshaft position sensor relearn today.
-
Fless reacted to c21ban's post in the thread SOLVED - Anyone know of a Hard-Wired Trailer Brake solution for a 2023 Tahoe? with Like.
I was skeptical as well and I haven’t ghosted . Just decided to give back the Tahoe to the dealership and wait for the MAX trailering...
-
Fless replied to the thread Crank Sensor.The ACDelco sensor is $60 on Rock Auto.
-
Stick out you say??? Who needs that. Thank God for soft shackles.
-
Fless reacted to OR VietVet's post in the thread Time sensitive question about cv axles, any help appreciated with Like.
Yes, sometimes the needle bearings fall over if you remove the cup for ANY reason and then you slide cup back on and the needle is...
-
I had great results on mine with the Por15. Just remember that thorough surface prep is the key with any product. Put in the time and be...
-
Fless replied to the thread Second o2 sensor slow.Swap the sensors left to right (or between equivalent sensors) and see if the code and sluggishness follow. Likely time for new O2 sensors.
-
Fless replied to the thread SOLVED - Anyone know of a Hard-Wired Trailer Brake solution for a 2023 Tahoe?.Thanks for posting your solution.
-
Fless reacted to cdavison's post in the thread SOLVED - Anyone know of a Hard-Wired Trailer Brake solution for a 2023 Tahoe? with Like.
Scratch this. I can now confirm that I am an idiot. Red white blue and black do not match up with GM’s red white blue and black. Once I...
-
Fless reacted to mwilson62000's post in the thread Back up camera...'05 Yukon... a safe location? with Like.
Originally had mine down in the hitch opening. Wasn’t bad, but decided to get a new one and moved up to under the hatch. Much better...
-
Fless reacted to OR VietVet's post in the thread Time sensitive question about cv axles, any help appreciated with Like.
So are you just doing the rear u-joint? If so, make sure the new cup that still need to be pushed in the U shape section of yoke, are...
-
Fless replied to the thread Time sensitive question about cv axles, any help appreciated.Be a bit careful with the beating. See post #33 about needle bearings getting out of place.
-
That's NOT what I'm talking about, and you know it.
-
-
Loading…
-
Loading…
