-
-
kbuskill reacted to mikez71's post in the thread Hood open message. Latch and BCM replaced. with
Like.
One of the connectors by the underhood fusebox & driver side fender liner might connect the hood latch to the BCM. (P103, X103 on... -
kbuskill replied to the thread Hood open message. Latch and BCM replaced..The BCM is looking for a ground signal on one wire or the other depending on latch position. The link @Fless posted should give you an...
-
kbuskill reacted to Fless's post in the thread Hood open message. Latch and BCM replaced. with Like.
A pulldown circuit like that is current-limited, and the internals in the BCM are made to recognize that as a switch, without...
-
kbuskill replied to the thread 2004 6.0 NV4500 Tahoe.I have drained the oil from new compressors and measured to be sure it was the correct amount. You are correct a little more won't hurt...
-
kbuskill replied to the thread 2004 6.0 NV4500 Tahoe.Assuming compressor came pre-filled with proper amount of oil. Did you add any extra oil?
-
kbuskill replied to the thread 2004 6.0 NV4500 Tahoe.Hard to say. Most of the time when you have a lot of trash on the orifice tube it means the compressor isn't long for the world, or it...
-
kbuskill replied to the thread 2004 6.0 NV4500 Tahoe.Yeah, the filter is there to keep trash out of that little tiny orifice.
-
Good to know. Every time I've had a mechanical failure, it's been full of debris. Good to know it's actual purpose
-
kbuskill reacted to j91z28d1's post in the thread Hood open message. Latch and BCM replaced. with Like.
a volt meter can read voltage where there's practically none since they are designed to add no load to the circuit while testing very...
-
kbuskill replied to the thread Hood open message. Latch and BCM replaced..I see what it says but it would seem to me that if the BCM is pushing power to that switch and the switch is connecting it to ground it...
-
kbuskill replied to the thread 2004 6.0 NV4500 Tahoe.Orifice tube is basically the metering valve and what causes the freon to go from a High pressure/liquid state to a Low pressure/gas...
-
kbuskill replied to the thread Hood open message. Latch and BCM replaced..The way I read the wiring diagram you shouldn't have voltage at either. The hood latch is just a simple switch that either connects the...
-
kbuskill reacted to ReaperHWK's post in the thread Hood open message. Latch and BCM replaced. with Like.
People are way too quick to replace the BCM when it’s almost never the problem. Get the schematic and check all wiring point to point...
-
kbuskill replied to the thread Smaller steering wheel.Yeah, I thought about that but figured having something machined to fit with splines inside and out would probably be cost prohibitive...
-
kbuskill replied to the thread Smaller steering wheel.The one I tried to use from a Buick Enclave looks identical except it has wood at the top and bottom. It was physically the same size...
-
-
Loading…
-
Loading…
