-
-
Thanks for the recommendation. Just removed the fuse and will be replacing the shocks soon. -
My recommendation is to remove the fuse activating the compressor, and leave it unpowered, until you replace both blown shocks. Then...
-
That’s the problem - I have! The problem never lasts long enough to hook up the Tech2 and troubleshoot while it’s happening. And there...
-
Welcome to the Forum from NH. Lots of knowledgeable folks here who freely share their knowledge, experiences, and perspectives...
-
Get your Tech-2 out Dave!
-
The short answer is I don't know for 100% sure. It's only happened to me once or twice and the rest of the time it's been my wife. The...
-
To add on to the other good suggestions, does the memory function cause the seat to move when the normal adjustment switch does not...
-
Big Mama replied to the thread Intermittent power driver’s seat.Yes. Mine would stick in the forward position my wife uses. The switch would move the seat from time to time. I took off the sill plate...
-
Big Mama replied to the thread Intermittent power driver’s seat.Mine was the memory control module under the seat.
-
Big Mama replied to the thread 2005 Yukon Brake Problems HELP! !.I had this problem when bleeding after replacing lines. I couldn’t solve it so I went to my indie. Turned out the be a cracked bleeder...
-
Air in ABS. Need a tech2 or similar while bleeding and 4-6 qts is kinda normal.
-
Big Mama replied to the thread C4 vs C5 Corvette. 5 reasons I chose the C5!.I almost bought a 98 FRC C5 but drove a C4 and owned a C6. The C5 was a way better all around car.
-
Not so many miles, but lots of smiles.
-
I haven't attempted to disconnect the switch yet. I was going to disconnect the battery for a bit and see if it reset properly. If that...
-
Hello, thanks for the replys. I took a closer look this morning, the latches look almost brand new. Truck has zero rust but I did notice...
-
-
Loading…
-
Loading…
