OilBurner2003
Full Access Member
- Joined
- Jul 24, 2022
- Posts
- 280
- Reaction score
- 170
Hey everyone! Yeah it’s me again, I had a tons of folks help me with the intake, and they were all such a great help! But I really think I did it with this one. As soon as I removed the paper towel covering the oil valley in the passenger side valve cover, a electrical connector rubber “Boot” fell right in from the harness. My fault. What do I do to get it out? It’s not visible from the oil valley hole, what are my options do you guys think? This happened when I was finishing my lower intake manifold install.
I made a new post because this is kinda something I want everyone’s opinion on if possible. 24# pages of troubleshooting on the last one is a lot to look through!
I made a new post because this is kinda something I want everyone’s opinion on if possible. 24# pages of troubleshooting on the last one is a lot to look through!
Last edited: