I tried places in Biloxi and north of me a bit (salvage yards). They were asking about the same amount...when they could get one. Also...this older panel is stout, but it takes a little longer bolts under the door handle to bolt panel to door...Could not make old bolts work. Thanks
What did you do to your NNBS GMT900 Tahoe/Yukon Today?
- Thread starter phattyford
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Charlie207
Full Access Member
Basically my reasoning.
After a few weeks they are groaning again and it looks like dog sht.
spitting on it doesn't work, use lithium grease
try this stuff. it's been my go too for the last few years. gotta shake it well and get some graphite flowing before hitting the hinge
Attachments
mikez71
Full Access Member
- Joined
- Mar 9, 2023
- Posts
- 805
- Reaction score
- 940
It's that hold door bushing! My driver side was worn so bad, it was off center. I had to pop the spring out to keep it from creaking.
Now I have a floppy door when open. I have a new door hinge, just need paint/install, BUT someone posted a cam roller repair kit not long ago..
Now I have a floppy door when open. I have a new door hinge, just need paint/install, BUT someone posted a cam roller repair kit not long ago..
That is white lithium grease.
that little sleeve right there is what is making the noise (most likely inside), goober that f-er up with some axle grease that should quiet it up, might be time for a new one if that doesn't work.
there's a tool for the spring removal.. it's pretty cheap too. I picked one up for my obs.
solli5pack
Full Access Member
- Joined
- Jun 17, 2023
- Posts
- 152
- Reaction score
- 224
Doorman 38300 will fix that right up! And it's greaseable. $25
Similar threads
