RooTBeeRthe1st
Full Access Member
- Joined
- Jul 11, 2018
- Posts
- 1,024
- Reaction score
- 2,354
I ended up painting mine silver with steel-it after I got them. The black clashed with the silver wheel to me.
But the black on black is the way to go.
What did you do to your NNBS GMT900 Tahoe/Yukon Today?
- Thread starter phattyford
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
I ended up painting mine silver with steel-it after I got them. The black clashed with the silver wheel to me.
But the black on black is the way to go.
iamdub
Full Access Member
It's bagged. Aired all the way up, it's higher than stock. He has the ride height pre-set, but he actually can drive and turn with it as low as physically possible. He doesn't drag it and all his wheels clear. That's more than I can say about mine.
Sparksalot
Supporting Member
That looks pretty cool.
Geoffsfas10
Full Access Member
Swapped into the new camposition sensor tonight. Not too bad a deal overall. Was actually easier to pull the intake tube and go at it from above with a long shaft flat head. The old came out in pieces, so maybe it was what was actually jacked up. I drove it around the block and then went grocery shoppi g. So far no light, fingers crossed its good tomorrow. I should know quick since it was all sorts of unhappy today before the sensor
Geoffsfas10
Full Access Member
after driving it all day and making lots of stops....so far no CEL....vs yesterday I got 3 CELs in 4 drives.
blackelky
Full Access Member
- Joined
- Oct 15, 2023
- Posts
- 510
- Reaction score
- 617
Finished changing out the coolant tees and dorman heater core hoses
My oil bleeding, lifter rattling shit box is still rolling and lookin good
blackelky
Full Access Member
- Joined
- Oct 15, 2023
- Posts
- 510
- Reaction score
- 617
Now the temp guage fluctuates between 210-230 hopefully the air is just bleeding out of the system
OR?Similar threads
