iamdub
Full Access Member From Li'l Weezyana
- Joined
Latest activity Postings About
-
-
iamdub replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.It'd be cheaper (about $25) to raise the front if all you really want is to be level. It'd make more sense being a 4WD that does boat... -
iamdub reacted to Just Fishing's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with
Haha.
It's a lowering kit, not a raising kit. ;) -
It’s for an e30 but the chassis’s are very similar...
-
iamdub replied to the thread Engine Swap to stroked 6.0 (408) and general vehicle refurbishment.It's been a while so I don't remember- what's the purpose of the Milodon oil pan? The stock one is a structural part of the lower end...
-
Get the SCPI to MPFI spider. It moves the injector down into the intake rather than the poppet style like OEM. Can’t get away from the...
-
iamdub reacted to Geotrash's post in the thread 2008 Yukon Denali Pressure relief valve deflector with Like.
The oil deflector is attached to the pressure relief valve in later models. You can safely remove the valve and plug the hole since...
-
iamdub replied to the thread 2008 Yukon Denali Pressure relief valve deflector.The valve in the oil pan that we're discussing is the pressure release for the AFM system. When it releases, the oil would spray out of...
-
iamdub replied to the thread Please help 07 GMC Yukon Denali mystery.After powersquinting, I see that that's the harness connector to your AutoRide shock. This would have absolutely no affect on the idle...
-
-
Well, I found a company who will quote insurance for replacement value and as a daily driver for a modified 06 Escalade. It is American...
-
iamdub reacted to MassHoe04's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
You can go to a mechanic, but you can also do a DIY check for free. If something is bad, you will most likely be able feel and hear it...
-
iamdub replied to the thread 2004 Tahoe LS - Street Touring Style.Square port heads FTW. Yes, they're not such an improvement over the cathedral port 799s when you have boost. But, they'll compliment...
-
Congratulations! I like your thinking on this build and the reasons for it. My "midlife crisis" was forced on me due to a transplant...
-
I looked at the drop spindles and the only thing that made me nervous was the trimming of the upper ball joint. The install...
-
I like your plan and your panoush to undertake the build and to participate in the Hot Rod Driving Tour. I’m doing something similar to...
-
-
-
Loading…
-
Loading…
