CaptainAmerica1
Full Access Member
Z71 springs and rear sway bar end links.
Plugs and wires too.
Plugs and wires too.
Last edited:
What did you do to your NNBS GMT900 Tahoe/Yukon Today?
- Thread starter phattyford
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
osiris94ej
Full Access Member
Yesterday i installed the front struts wrong.
Today I fixed that.
Sent from my SM-N950U using Tapatalk
Today I fixed that.
Sent from my SM-N950U using Tapatalk
trailblazer
Full Access Member
- Joined
- Jan 22, 2019
- Posts
- 281
- Reaction score
- 394
I believe the entire GMT900 series you need to buy the entire assembly. I had to do this on my ‘08 2500HD. IIRC it was about $75 for the bottom spring one. They all go bad on these GMT900’s unless you’re aggressive with the lube.
CaptainAmerica1
Full Access Member
How did you install them wrong?Yesterday i installed the front struts wrong.
Today I fixed that.
Sent from my SM-N950U using Tapatalk
I just did this with the 12$ ebay one from China. Works fine.
Sent from my SM-G973U1 using Tapatalk
Tonyrodz
Resident Resident
Probably last 6 months.
osiris94ej
Full Access Member
Had too many ring's under the lower perch. Had them set for stock height. Misunderstanding of the instructions.
Sent from my SM-N950U using Tapatalk
5strmtrp
Full Access Member
- Joined
- Jul 28, 2019
- Posts
- 365
- Reaction score
- 384
Yesterday i installed the front struts wrong.
Today I fixed that.
Sent from my SM-N950U using Tapatalk
I’m assuming right on the left side, left on the right side?
osiris94ej
Full Access Member
Instructions were unclear. Got dick stuck in ceiling fan.
I stacked the rings up from 3" of max drop. The chart confused me. Had to take them to work and take apart again and take the rings out.
Sent from my SM-N950U using Tapatalk
Similar threads
