What did you do to your OBS GMT400 Tahoe/Yukon Today?

[noJeepshere]

Hey guys so I was thinking of buying this 2000 nbs Tahoe center console for my obs Yukon what do you guys think? Opinions? http://item.mobileweb.ebay.com/viewitem?itemId=140929915452&index=0&nav=WATCHING&nid=58862224940

Want.

 

[VicYukon]

@Monstar_est87 I actually don't want the front piece I don't like how they look when they get to the bottom of the dashboard. So I know that their is a little gap that shows in front of it but thought I would make a piece/plate cover for it.

 

[96redsport]

flares and leds

Which LEDs did you use for the map lights??

 

[YUKON1999]

Is was these because they fit and were white

http://www.superbrightleds.com/more...led-bulb-5-smd-led-wide-angle-wedge-base/206/

 

[96redsport]

Plug and play or with some alterations?

 

[SunlitComet]

i recently started converting to these but the smallest diameter section of the bulb holder needs to be ground open a bit and i removed the lens to put them in. in the end i chose to leave the lenses off for now instead of gluing them back on. Totally awsome. must do the same or bigger for under the dash as the 120° singles( no alterations but horrible output on reading lamps) just dont cut it. http://www.superbrightleds.com/more...-led-bulb-9-smd-led-wedge-base-tower/207/925/

 

[96redsport]

Cool... Got all my interior lights done over to LEDs except the map lights, thanks for the info.

 

[Donnie Yukonie]

bushwacker

Those were expensive Last time I priced them they where 3 or 400 bucks

 

[YUKON1999]

Yeh I paid 450 and then I found the pocket style for cheaper, those were what I wanted to have but couldn't find them

 

[YUKON1999]

does anyone know of a clear cover for the rear cargo lamp instead of that white cloudy cover

 

[Donnie Yukonie]

does anyone know of a clear cover for the rear cargo lamp instead of that white cloudy cover

here you go!

http://www.lmctruck.com/icatalog/csd/full.aspx?Page=53

 

[YUKON1999]

nice thank you, i take it you got one already

 

[SunlitComet]

lmc just start selling those in the last few months i think.

 

[96redsport]

I got 2 of those covers just last month... Worth it.

 

[96ProCompTahoe]

cleaned out the interior a little, hoping to have good weather this coming week to get it out and washed and detail the inside.

 

[Donnie Yukonie]

lmc just start selling those in the last few months i think.

You would be correct sir

nice thank you, i take it you got one already

No but it is on my wish list lol

I got 2 of those covers just last month... Worth it.

Pics installed?

 

[SunlitComet]

got my engine torque and tranny temp to show up and register on my scangauge 2 today.

---------- Post added at 12:39 PM ---------- Previous post was at 12:39 PM ----------

You would be correct sir

i usually am.

 

[_Dylan_]

bought a window motor from a mitsubishi and a chevy window switch for my cutouts

 

[SunlitComet]

Put the scangauge 2 into a new spot.

 

[Goldhawg]

Changed my spider from poppets to new style; put new cap/rotor/wires/plugs & volant airbox. Also swapped the steering sensor. Waiting to drive it tomorrow to see if steering improves.