What did you do to your NBS GMT800 Tahoe/Yukon Today?

[LsHart]

PUT these in the doors today and got the inside bulbs to go blue like the doors.

 

[LsHart]

Sorry my nub finger is in the pic! Lol

 

[mikez71]

Unscrewed my antenna so I could go through the carwash, but it ended up unscrewing the middle part of the base!
I think I can screw it back in.. but I'm epoxying the tab that broke on the cowl piece first..

Also a small piece of hood paint flaked off starting from a rock chip..

Anyone go through a flap-roller carwash with the solid antenna? This burb is too big to wash by hand...

 

[Fless]

Anyone go through a flap-roller carwash with the solid antenna? This burb is too big to wash by hand...

I go through the flap-roller wash most of the time. Not real often, but it's rare that I wash the Hoe at home. Stock antenna. The wash moves the mirrors around a little but they're made for that.

 

[Roilux]

Anyone go through a flap-roller carwash with the solid antenna? This burb is too big to wash by hand...

I swapped my factory antenna for a 6" stubby. Reception is fine and when the beast gets a flap wash to scrub the top, there's no antenna drama.

 

[mikez71]

Screwed the antenna back in, thanks for the replies. Will replace with a stubby if it ever gets ripped off at the carwash!

 

[mountie]

I remove the antenna….. I cancel the final ‘roller dryer’…… It tries to take off my wipers.

FYI…… This morning, I’m flying to the Wine Country in N. California for 10 days…. ( Family-friends to see )

Back in a little while……. HAPPY 4TH !!

 

[nonickatall]

Today I changed the oil, touched up the rust protection on my car, diagnosed the faulty LPG system level indicator and ordered a new one, ordered new keys and a remote key fob, put on summer tires, and reprogrammed the tire pressure sensors.

Then I wanted to replace the transmission switch and discovered it was the wrong one.

So I have to order a new one...

 

[6speedblazer]

Fixed my two broken exhaust manifold bolts. Front and rear bolt on the drivers side were broke flush. Pulled the manifold and welded nuts to them. Front one i got first try. Rear one was stuck pretty good and fought me a while.

Installed arp stainless bolts, new gm gaskets, new plug and wires.