-
-
66speedblazer replied to the thread Play where intermediate steering shaft meets gear box.Reading comprehension got the best of me on that one.
-
66speedblazer replied to the thread Play where intermediate steering shaft meets gear box.There is an adjustment to the gearbox that can be done. I have tried it many times and have never successfully removed slop from the...
-
66speedblazer replied to the thread Engine kick back on start up.Sounds kind of similar to this bulletin
-
66speedblazer replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.i would have to dig up the part number. its a 90* fitting with 3/4" quick connect and 5/8 hose barb on the other end.
-
66speedblazer replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.Keep this updated, I have been planning out the same upgrade on my escalade just haven't got around to it yet, I retrofitted my Denali...
-
66speedblazer replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.Dont forget the ones for the rear heatercore. Mine crumbled when i took them off.
-
66speedblazer replied to the thread 2004Denali P0446 Code.That code is for the vent solenoid, not the purge solenoid. Purge solenoid is located on the engine; vent solenoid is located on the...
-
66speedblazer replied to the thread New to the forum, i have a 2004 Yukon with a 5.3 with a crank, no start issue.Will it start on starter fluid?
-
66speedblazer replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.Nah. I had it set to 89 ft lb and snapped a bolt. After I put my digital adapter it read 125 when it clicked over at 89. This thing is...
-
66speedblazer replied to the thread EDC toolkit design.Yes that tool kit is printed. Mine came with a mechanical bottle shaped one. But I was referring to a hydraulic bottle jack.
-
66speedblazer replied to the thread EDC toolkit design.I also keep on of these plus an extension and socket in each truck. I also have the socket used to change the tire on my trailer...
-
66speedblazer replied to the thread EDC toolkit design.This fits under one of my middle row captains chairs. The one tray lifts up and i have a ratchet and stuff in there too.
-
-
66speedblazer replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.I'm not mad, I'd rather her be outside with me, than inside playing on a tablet or something.
-
66speedblazer replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.My 6 year old made that for me shortly before she messed up my shim layout and I had to redo all my setup again.
-
66speedblazer replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.Installed a truetrac in my escalade. This job turned into a bit of a headache for various reasons, but i was able to get it resolved...
-
-
-
Loading…
-
Loading…
