MassHoe04
Full Access Member
Bulb just went out on the front passenger side. No sense in putting another old and dim bulb in again... I'll be getting these soon.
What did you do to your NBS GMT800 Tahoe/Yukon Today?
- Thread starter vwbeaner
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Does yours have lights in the 2nd row doors? My '04 LT has reflectors.
MassHoe04
Full Access Member
I doubt both sides would be burnt out, so from the looks of it... The rear doors on my 04 Z71 are only reflectors.
HansJr
Full Access Member
Finally got my old droopy headliner out and it rewrapped in black. Just put back in. Looks good imho.
HansJr
Full Access Member
The little finger dimples in the picture smoothed out overnight. Installing alone had me finger punching the liner while installing.
iamdub
Full Access Member
Weakened suction from a vacuum cleaner hose can be used to gently pull out any remaining dents. A soft brush attachment usually works well.
HansJr
Full Access Member
Thanks. The heat overnight already smoothed it back out. It’s got fresh backing so it’s super soft.
Started my Big Brake upgrade with Power Stop kit (from a 2008) and new GM OEM rubber hoses. I broke 3 bolts (2 on one side and 1 one other that hold down brake hose) and drivers side hose might be permanently rusted to hard line. So i might have to repair last few inches of the hard brake line. Ill be drilling and tapping upper control arm and both knuckles, *@$&*@×&!!! Is the control arm hold down bolt same size as the knuckle hold down bolt?
Attachments
Tightened up the steering gearbox two full turns. We went all the way to 3.25 turns but that was way too tight. Happy with it now!
Installed another heater hose today after a parts delivery and got the OEM tees in, pressure tested the system. No leaks. Now waiting on the new rear ac refrigerant lines to be delivered. Finally stopped buying more parts. I think. 
