MassHoe04
Latest activity Postings About
-
-
Run all the switches (4hi, 4lo, auto4wd, 2wd) all through the positions. Exercise it which will clean the the commutator ring down in... -
MassHoe04 replied to the thread Time sensitive question about cv axles, any help appreciated.I could see that happening if the cap seals were still holding tight. Definitely would want to be sure to have it pointed away from you...
-
MassHoe04 reacted to OR VietVet's post in the thread Time sensitive question about cv axles, any help appreciated with
Like.
I have seen the cups literally pop out of the ears when the pressure releases after heated. -
MassHoe04 replied to the thread Time sensitive question about cv axles, any help appreciated.Basic hand-held propane torch (BernzOmatic) I used was sufficient heat to melt out the plastic on U joints I did on my Jeep last year...
-
MassHoe04 reacted to Blackmar401's post in the thread Time sensitive question about cv axles, any help appreciated with Like.
I have a fullsize oxy acetylene setup. I'm a union pipefitter/welder. I'm actually very handy I'm just not very knowledgeable on cars. I...
-
try moving the radio ground, ground the head unit to somewhere more solid and see if that resolves it.
-
Check the positive cable between the alternator and the battery. I have heard of that cable disintegrating inside the protective case...
-
Make sure you have a good ground that's the most common problem.
-
MassHoe04 reacted to swathdiver's post in the thread question on ordering front wheel bearing with Like.
Some time ago with another car, we were broke and in a hurry and bought a Chicom hub. The fit and finish was great, the ABS sensor...
-
MassHoe04 reacted to ShookieJay's post in the thread NP246 Auto 4wd Transfer Case Owners Beware! with Like.
Just wanted to share my experience with y'all and hopefully save someone the headache of blowing up their transfer case. So I bought my...
-
MassHoe04 replied to the thread Intermittent SERVICE 4WD Message.Everything came back to normal last night... I think I'll hold off on doing anything further or getting any parts until something...
-
That sounds like a button or Tcase module problem. Doesnt fit the symptoms of the dirty commutator ring in the shift motor that is...
-
MassHoe04 replied to the thread question on ordering front wheel bearing.I got mine from NAPA. Their premium hubs with sensors are SKF brand, which I later found out is actually Timken. My emergency repair...
-
MassHoe04 replied to the thread Time sensitive question about cv axles, any help appreciated.The one in the photo sure looks to be original. You can see the plastic nibs on the ears of the yoke. That is where the plastic used to...
-
-
MassHoe04 reacted to OR VietVet's post in the thread Changed thermostat, Coolant temperature stays at 185 degrees with Like.
A heat soak takes place every time you get the engine to operating temp and then shut off. The engine temp climbs higher then because...
-
-
Loading…
-
Loading…
