Recent content by Jons2005tahoe

  1. Jons2005tahoe

    04 Tahoe starting issue

    That sounds like your starter. Next time it does it hold the key in the start position and have someone tap the starter with a hammer, if it starts that's your problem. Sent from my iPhone using Tapatalk
  2. Jons2005tahoe

    Help 5.3 keeps throwing serpentine bel

    i would check all your pulleys with the belt off. check the pulleys to see if they are clean and with no damage, check the tensioner (even though its new) for cracks or looseness in the housing. with the belt on look across all the pulleys to make sure they are all straight. the problem may only...
  3. Jons2005tahoe

    Mileage Thread (00-06)

    2005 Tahoe 111400
  4. Jons2005tahoe

    Bottoming out problem

    Look for any cracks in the frame. And check the ball joints. You could also check the spring or torsion bar depending on if it's 2 or 4wd Sent from my iPad using Tapatalk
  5. Jons2005tahoe

    Anybody know what this connector is to?

    Both the truck and suburban we have don't have that plug Sent from my iPhone using Tapatalk
  6. Jons2005tahoe

    Anybody know what this connector is to?

    We have a 98 at work I'll look at it tomorrow to see if I can figure it out Sent from my iPhone using Tapatalk
  7. Jons2005tahoe

    Anybody know what this connector is to?

    Ok how about air temp sensor? Sent from my iPhone using Tapatalk
  8. Jons2005tahoe

    Anybody know what this connector is to?

    Maf sensor Sent from my iPhone using Tapatalk
  9. Jons2005tahoe

    02 Tahoe died on my way to work.

    Give it a shot of ether if it starts. It might be your fuelpump is bad Sent from my iPad using Tapatalk
  10. Jons2005tahoe

    new rear brakes sqeaking

    X2 on the rotor turning and you can probably get the pads replaced under warranty. Sent from my iPad using Tapatalk
  11. Jons2005tahoe

    :wtf: HELP!! L.e.d a/c conversion

    x2 those look awesome
  12. Jons2005tahoe

    :wtf: HELP!! L.e.d a/c conversion

    according to his pics and directions you don't need resistors on the bulbs just the wire that supplies power to them nvm now that I look at again he has resistors on the wire to the second board and on the lights on the first board
  13. Jons2005tahoe

    Rear end

    Any rear that is the same width will work you can also find a posi (g81) or limited slip (g80) then a range of ratios just check the codes in the glove box
  14. Jons2005tahoe

    Stupidity is painful.. broke a connector. Ideas?

    Try zip ties Sent from my iPad using Tapatalk
  15. Jons2005tahoe

    Some Error codes!

    Have ran a compression and cylinder leak down test. Also your problem could be caused by leaking intake gaskets.
See more

Forum statistics

Threads
129,220
Posts
1,812,351
Members
92,321
Latest member
rick3645

Latest posts

Top