Show off your 2015+ leveled Tahoes and Yukons!

[K2 Kaiju]

Pre and post with motofab 1.5" level...

Sent from my SM-G975U using Tapatalk

 

[jackedupZ71]

View attachment 224502

any rubbing with this set up? thinking of doing a 33 on 20” 5660 reps


Sent from my iPhone using Tapatalk

 

[mike bz06]

For those of you running the 2" RC level, does it still have rake? or is it completely level? I know I've ran the 2" RC level on 2 Silverados now, and each time the front is still lower Than the rear.

 

[Dave Legacy]

With absolutely nothing in the truck my measurements were 1/4” higher in the rear and it looked nose-high - an illusion. I think it has something to do with the arches, gap, or something.

 

[Anthony Zielinski]

1.5” Suspension Maxx Level Kit. 305/45/22 hankook dynapro atm tires


Sent from my iPhone using Tapatalk

 

[CMechanical]

View attachment 227425 View attachment 227425

 

[CMechanical]

No lift kit. This was the result after installing Strutmaster mag-ride delete kit.

 

[olyelr]

No lift kit. This was the resort after installing Strutmaster mag-ride delete kit.

So what was the results? 1”? 2”?

And how did the mag delete go? Our shock are due for replacement and I am looking to go a different route from oem possibly.


Thanks!!!

 

[CMechanical]

So what was the results? 1”? 2”?

And how did the mag delete go? Our shock are due for replacement and I am looking to go a different route from oem possibly.


Thanks!!!

It raised the front 3" and the rear drop 1/2" so from ground to wheel well is 37 1/2 in rear and also 37 1/2 in front. This was a shock and spring replacement front and rear. Ride is very floaty feel. Also rocks side to side pretty bad when going over bump at a angle. Pulling into driveways est. Believe strutmaster has got the set up wrong for the 2015 and up. Kit was a GC2FB (2007-2012) Was suppose to be kit GC44F (2015-2018). Sales Rep said it the same shocks and springs in both kit. Just the electric bypass kits are different. Working with tech support about getting the front back down to the shock height.
For mag delete they supplied resisters with water tight fuse. Just cut connector off old shock wire in the resister wire hardness. Also just remove fuse for air pump. No warning lights so far.
For now I'm disappointed in kit. It rides better with the wore out front mag shocks. Probably will just go back to mag ride shocks. If strutmaster can't correct. Rockauto has the for around $318 a piece. Total cost around $1300 plus my labor. Strutmaster kit was $737.38 plus my labor about 6 hrs so far.

 

[jackedupZ71]

ended up going with 285/60 toyo ats and 2” suspensionmax leveling kit. only rubbing was on right rear inner fender liner, a little heat and massaging and it was good.

Sent from my iPhone using Tapatalk

 

[olyelr]

ended up going with 285/60 toyo ats and 2” suspensionmax leveling kit. only rubbing was on right rear inner fender liner, a little heat and massaging and it was good.

Sent from my iPhone using Tapatalk

Are those 20” knockoffs of the oem denali 22’s?

Looks good!!

 

[jackedupZ71]

Are those 20” knockoffs of the oem denali 22’s?

Looks good!!

yeah they are, thanks!


Sent from my iPhone using Tapatalk

 

[Noah LeBlanc]

2” front 1” rear
275/60/20 KO2’s

 

[15TahoeLT]

2015 Tahoe LT
Fox Coil Overs up front 2" lift
Freedom Off-Road UCAs
3/4" Rancho Rear Spacers
275/60/20 K02s

 

[Dave Legacy]

2015 Tahoe LT
Fox Coil Overs up front 2" lift
Freedom Off-Road UCAs
3/4" Rough Country Rear Spacers
275/60/20 K02s
View attachment 227900






View attachment 227899

Have a part number for the 3/4” rear spacer from RC? I’m assuming it’s not advertised for this application? I’m running a 3/4” poly Daystar. It’s working, but I’m not loving it (deforming a bit).

 

[15TahoeLT]

Have a part number for the 3/4” rear spacer from RC? I’m assuming it’s not advertised for this application? I’m running a 3/4” poly Daystar. It’s working, but I’m not loving it (deforming a bit).

Shit, I just looked up the order and it's not Rough Country- it's Rancho (part #RS70075). Same deal though it's Polyurethane. I know McBay Performance makes 1/2" and 1" spacers in aluminum but I haven't seen any 3/4".

 

[Dave Legacy]

Shit, I just looked up the order and it's not Rough Country- it's Rancho (part #RS70075). Same deal though it's Polyurethane. I know McBay Performance makes 1/2" and 1" spacers in aluminum but I haven't seen any 3/4".

Thanks for clarifying. Looks identical in design to my daystar 3/4” poly spacers. Mine are working fine, but one of them looks a little “smooshed” for lack of a better term and sit on the axle seat a little sloppy so I’ve been looking for a better fit.

 

[Scottcubed]

2015 Tahoe LT
Fox Coil Overs up front 2" lift
Freedom Off-Road UCAs
3/4" Rancho Rear Spacers
275/60/20 K02s
View attachment 227900

Looks good






View attachment 227899

 

[Ccarterz71]

285/55/20 KO2
Bilstien 5100’s on all 4 corners

 

[AZ Rat]

2017 Yukon Denali 4x4

2.5” Front / 1.5” Rear SuspensionMaxx
285/60/20 BFG All Terrain KO2

View attachment 224286

I still rub a bit but since I installed the rear shock relocators it rides like stock. TOTALLY Love it!