-
-
Ddkad260 replied to the thread Rear U joint replacement.Thanks for that info, greatly appreciated. Could someone verify the part#'s for the front and rear? I assume the top two are for the...
-
-
DLearned these steps years ago and works great. Have to have a steady hand and attention to detail but it works.
-
Ddkad260 reacted to NickTransmissions's post in the thread 2008 5.3/4l60e 3-2 downshift flare. Corvette servo? Extended servo pin? with
Love.
Dustin, Drop the pan and check your 2-4 band clearance by moving it back and forwards using a flat blade screwdriver. You should see no... -
DFor the rear of a '12 Yukon, are these retained by a clip or are they epoxied? They look to have clips but the front looks to have...
-
Ddkad260 replied to the thread 2008 5.3/4l60e 3-2 downshift flare. Corvette servo? Extended servo pin?.Something that happened to my 4L60E in my Envoy around 160K, was a 2-3 flare on acceleration. One of the check balls was pretty much...
-
DCheck your power steering fluid. Had a similar issue on my 2008 after it got hot climbing mountains in CO. I found that a little...
-
DThe airbag is integral to the "cover." It will need to come off to see the connections inside the steering wheel hub.
-
Ddkad260 replied to the thread Need help diagnosing "Service Air Bag".Thanks, I'll do that. Looks like all of this circuitry is under the airbag cover?
-
DLikely the clockspring, but possibly the airbag. You can substitute a resistor in the clockspring's airbag circuit (at the clockspring...
-
D2012 XL Denali. This is what comes up on the Tech 2. Hopefully just a sensor up front. The code will not clear also, comes right back.
-
-
Ddkad260 replied to the thread 2011 Suburban - Front end shakes.Any updates on this? I had a slight steering wheel shake for about a month, I did need to change my RF hub and bearing so I replaced...
-
Ddkad260 reacted to t_bergman's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Like.
Added wireless charging to the 2500 today; install was very straightforward and I only made one modification. In the second picture I...
-
Ddkad260 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.Front GM# is 19420494. Rear Arnott is 2708, my gut tells me that even though the 2708 is a factory replacement, that the OE BDI might be...
-
Ddkad260 reacted to iamdub's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Like.
Gray/silver is for body panels that will be seen. Duuuuh! Back around '92, I had a few rounds of Buttery Nipples with some GM...
-
Ddkad260 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.If it's the heater core, you will generally get condensation on the windshield when using defrost, so try that. Double check the...
-
-
Loading…
-
Loading…
