Cruise control out need detailed help

[BLKCaddy]

I have a 05 Yukon slt, I have led tail lights and break lights work but interior lights "front, when door opens" do not work anymore. I check the cruise fuse "still good" so what do I do next?

 

[OmarR]

Did you just install the tailights? If they do not have load equalizers built in, they will render your cruise control inoperable.

For the interior lights, did you check the dome overide button? If not pressed in, you may need a new switch. Do the rear doors or hatch trigger the interior lights?

 

[BLKCaddy]

What can I do if the tail lights do not have the load equilizer?

 

[yates ™]

Change them back to factory lights and see what problems still exist. 1st thing to trouble shooting anything is if you recently switched to an aftermarket part and there is trouble revert to stock and trouble shoot from there.

 

[BLKCaddy]

Ok, Cruise works with oem taillights.

What do I do to make the aftermarket ones work, if there's anything I can do?

 

[chauncey0337]

Install load resistors.

 

[BLKCaddy]

Where do I put those, details please

 

[OmarR]

Do a search, its been discussed several times.

 

[chauncey0337]

Fine, I'll search...
http://tahoeyukonforum.com/forum/showthread.php?t=27228&page=8

 

[BLKCaddy]

I think those are on there, heres a pic! I might not have hooked them up right as far as what light out goes where.

 

[chauncey0337]

That is indeed a load resistor. Easiest way to hook them up is connecting them to the brake light plug. You can see which wires in the link I posted above.

 

[BLKCaddy]

I tried that configuration but no cruise, right turn signal flashed as if the build was out and remote start didn't work. Not sure what happened.

 

[BLKCaddy]

Cruise works with the taillights but for some reason having issues with the break lights part.

Any ideas???

The setup for how the lights are plugged in for the oem tails are reverse for the aftermarket tails. So I have to flip them vertically, in the pic I posted the red goes to the top, the white is the middle and the other is the bottom but the bottom light doesn't work. Hope that wasn't too confusing.