I have a 01 NBS Tahoe with 6-way power seats. The driver's seat base has recently begun to slide ever so slightly forwards and backwards without the motor. The upper rail with the seat, is sliding along the lower stationary rail which is bolted to the floorboards of the truck, all on its own...
I've been thinking about lowering/droping my 01' Tahoe to fill some more of the wheel wells. Also a larger wheel which means new tires. I'll keep the 20" wheels on hand, but want a different look option as well. I hear that OHTSU are pretty good tires made by Falken.
I think my traction control system is fouled up. The button doesn't turn the lamp off. Any thoughts? Anyone know how to troubleshoot the system and wiring/switch?
I have a 2001 Tahoe with the manual controls 3 knobs fan, temp, and area setting. Everything seems to work just fine except the recirculate to fresh and back and forth. Sometimes it just seems to ignore the setting from the area knob to recirculate or the button itself. I've swapped the...
I was cruising the other day and switched on the headlamps, and the cruise control dropped out. Could not turn it back on as long as the headlamps were switched on. Does not happen when lights are automatically on at dusk. I recently got a replacement bulb and receptacle from DDM tuning and...
Any recommendations on a tablet or a ready made solution to a tablet installation? I had a Google Nexus 7" last installed behind my DD dash, but power and no back up camera available back in 2011. Any updates?
I'm looking for the cause of my loss of coolant. I'm losing about a gallon of coolant every 4-5 days and none of it is in the engine bay or on the ground. I'm not overheating, or driving roughly, no coolant in the oil drained while cold. The previous kerosene flush/oil change was due to a...
I'm replacing my front calipers only and stainless steel brake hoses for all 4. Any tips on doing this job? Should I flush the brake fluid 1st or after installing the new calipers and lines? I"m thinking that I should flush before exposing the new calipers and hoses to the old fluid.
Can you mix these? My 2001 5.3 NBS ignition coils aren't all the same. #1 cylinder has a round coil and all of the remaining coils are square. I discovered this while chasing down a misfire that I apparently created. I removed both coil harnesses to test the coils, and I don't remember if...
My 00' NBS Tahoe was about 4 hrs into a 8hr road trip two weeks ago when I noticed the infamous lifter tick sound, and my pressure dipped from about 35-40psi to about 20psi. I stopped and checked the oil, and it showed that I was about 3 quarts low. I added a quart and continued on my way...
I have been researching my e-fan upgrade, but I'm falling short of wiring my relays. Ok, first I'm not using any PCM programming or plan to nor do I want to over cool the engine with both of these fans so keep me honest if I'm repeating flawed information here. I got dual OEM fans and the...
Need help where do I cut or from main and get any inline relays from an 05'. Found an owner parting out- wants $20 for the fans. Going to get them tomorrow, appreciate any advice from the gang. I've got an 00' that I want to upgrade. Thanks!
Ok guys, thanks upfront for the help. I think I may have made a mistake sometime back by moving these ground wire to this location. I don't think those bolts are actually on solid frame on the firewall. The red wire is an extension of my crankshaft position sensor wire, and the mesh steel...
Any suggestions on known good locations to ground my alternator to the chassis? Preferably in/under the engine bay or front end. I know there's a spot under the driver's side door that is used for the ECBM module and there appears to be some free spots next to it, is it ok to use for the...
I have a Delphi 140 amp alternator and 0 gauge ground wire and battery wiring. However, I'm noticing that when I my turn signals are on, the voltmeter ticks up and down at the exact pace of the signal tick. Any ideas?
Can anyone validate that they've heard of this ? If so, please share info on how to fixed by dealer. Another member mentions it in a thread but I cannot get a confirmation from GM/Chevy for my VIN.
My driver's side seat has a horizontal lumbar is not moving back and forth, but I can hear the motor engaging. What is the part - (cable or belt) that is likely broken inside the seat under the padding? I'm assuming that something must pull and push the two side lumbars together and apart...
My 01 Chevy Tahoe LT is pretty well maintained by me. I've got a history of problems with L460e tranny rebuilds going out frequently (meaning I've bought 4 rebuilds over 19 years). I experience an issue while cruising up inclines at around 50mph and 1k-1.5k RPM that feels like a jerky...
This is a push washer which holds a piece in place on the visor track. Does anyone have experience removing these and do you know where to find replacements?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.