swathdiver
Full Access Member
I see another long-term quest and project!
What did you do to your NNBS GMT900 Tahoe/Yukon Today?
- Thread starter phattyford
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
I see another long-term quest and project!
ya if you want to mess with the headliner it wouldn't be that difficult to patch wires to the pillar buttons with my luck I would probably tear the headliner or something and it would turn into a $500 repair project i'm already at $120+ just for trying to replace a stupid bulb.
Monz11
Full Access Member
I have a pair of 3rd row black leather folding pull out seats, I want to offload, if yall are considering adding third row?
usually the 3rd row are vinyl are you sure they are leather?
Not in my future... manual release works fine for me...
seriously, i usually use the lever in the second row...not sure why but i rarely hit the button right there...
sure youve seen it now but the older models have switches for the power fokd in the upper console and on the c pillar....
George B
¯\_(ツ)_/¯
I only have switches in the C pillars.
The Escalade I robbed my second and third out of had both the c pillar and front switch... I waved at emm as I left them at the junkyard...
CHOO CHOO
BackPagePhil
After going to my brother in law's yesterday, 106 miles each way, filled up before coming home, and ended up with this. I'm not complaining one bit. All turnpike going 75 or highway going 65. Maybe 10 stop lights in between.
avalonandl
Full Access Member
18 mpg not bad
Drok
Full Access Member
seriously, i usually use the lever in the second row...not sure why but i rarely hit the button right there...
me too. Probably cause I forget about the button haha
Doing a cam swap in the Silverado today, got the cam in without dropping a lifter but didn’t realize I needed a single bolt to 3 bolt cam gear for the VHP cam so until that gets here tomorrow about the only other thing I can do is the Smith Bros trunnion upgrade.
gooffeyguy
Tom
I never use the levers for the middle row, unless I'm sitting there and I want to recline the seatback. I always use the C pillar button.
When I take my dog to the vet or to the groomers, I tumble the middle row seats and use a little bungee cord wrapped around the front headrest post to the metal latch bar thats at the top of the middle row seat when folded forward. This keeps them from falling back down while driving.
I put her blanket on the 3rd row seat, and she'll either lay on the 3rd row or on the floor.
Sent from my SM-G930V using Tapatalk
When I take my dog to the vet or to the groomers, I tumble the middle row seats and use a little bungee cord wrapped around the front headrest post to the metal latch bar thats at the top of the middle row seat when folded forward. This keeps them from falling back down while driving.
I put her blanket on the 3rd row seat, and she'll either lay on the 3rd row or on the floor.
Sent from my SM-G930V using Tapatalk
Your a mad man. God bless ya.
cfmistry
Full Access Member
- Joined
- Dec 5, 2018
- Posts
- 249
- Reaction score
- 424
What sorcery is this?? My car is bone stock, runs well, has 22" rims and I can't break 15.5mpg.
CHOO CHOO
BackPagePhil
Blackbeard tuned. ....that's the sorcery.What sorcery is this?? My car is bone stock, runs well, has 22" rims and I can't break 15.5mpg.
Cai, long tubes, no cats, borla exhaust, and a mpg tune from Blackbear. 87 octane 22" wheels as well.
I’d be complaining- there’s a check engine light.After going to my brother in law's yesterday, 106 miles each way, filled up before coming home, and ended up with this. I'm not complaining one bit. All turnpike going 75 or highway going 65. Maybe 10 stop lights in between.
Yeah, what’s that about?!
CHOO CHOO
BackPagePhil
Engine was off, just turned the key to get everything on
Rpm is at zero. That's definitely a problem if my engine is on
