Deephaven
Full Access Member
- Joined
- Mar 25, 2013
- Posts
- 263
- Reaction score
- 4
She runs!
What did you do to your NNBS GMT900 Tahoe/Yukon Today?
- Thread starter phattyford
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
CJKendall66
TYF Newbie
Goodinblack
I Like Tacos
JML07denali
Full Access Member
- Joined
- Mar 23, 2014
- Posts
- 874
- Reaction score
- 368
X2 more info please
Deephaven
Full Access Member
- Joined
- Mar 25, 2013
- Posts
- 263
- Reaction score
- 4
Got the tune iterations all ready for a WOT pass tomorrow.
I'll share details later, right now I am focused on making sure she is all buttoned up.
I'll share details later, right now I am focused on making sure she is all buttoned up.
Deephaven
Full Access Member
- Joined
- Mar 25, 2013
- Posts
- 263
- Reaction score
- 4
First WOT run. Just to 3rd gear. A bit fat on gas atm, but next tune iteration ought to get that much closer.
Deephaven
Full Access Member
- Joined
- Mar 25, 2013
- Posts
- 263
- Reaction score
- 4
It has its own water pump and radiator. It's are around 65 or so in my early testing
AC belt tensioner started to make helluva noise while cold a few weeks ago, so went ahead and changed it and both belts. Nice and quiet once again.
Once I was done and went to start, it only clicked. Has done it a couple of times before, too, but still started after a couple of tries. Has new battery/alternator and the cables are tight, so the only thing left is the starter, so I crawled back under there and noticed that the cables were slightly loose. Tightened them as much as I could in the tight space and so far starts nice and easy and no more clicking.
Probably should've changed the other tensioner, too, as well as the idler pully, but maybe later. They're pretty easy, anyway.
Once I was done and went to start, it only clicked. Has done it a couple of times before, too, but still started after a couple of tries. Has new battery/alternator and the cables are tight, so the only thing left is the starter, so I crawled back under there and noticed that the cables were slightly loose. Tightened them as much as I could in the tight space and so far starts nice and easy and no more clicking.
Probably should've changed the other tensioner, too, as well as the idler pully, but maybe later. They're pretty easy, anyway.
Deephaven
Full Access Member
- Joined
- Mar 25, 2013
- Posts
- 263
- Reaction score
- 4
6203 bearing and a wire brush and you are golden
CrashTestDummy
Full Access Member
Replaced the last stupid plastic plug in the roof with a proper antenna. Fixed the intermittent light out on one of the bulbs in the middle dome light.
7SubTrooper
Member
Did my first mobile 1 synthetic oil change on the 07 Sub. Just took it into the dealer for my first one. 137k on it and the oil still looks clean.
- Joined
- Jan 3, 2011
- Posts
- 50,943
- Reaction score
- 19,372
Put 500+ miles on her. Now has 159k
7SubTrooper
Member
That's 10k now than my 1986 k30 crew cab has on it
JennaBear
Resident Ninja
To sell or not to sell...
CHOO CHOO
BackPagePhil
Finally got it back and had these put on
