SnowDrifter
Full Access Member
Missing 2 of the little flippy flap dingus ends that go in the cup holder. I can't seem to locate replacements. Anyone know where to get these?
Cup holders
- Thread starter SnowDrifter
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
iamdub
Full Access Member
Last edited:
I would assume you have checked salvage yards. I checked GM Parts, Amazon has lots of aftermarket choices that could be adapted, I think.
Good find. Or this instead:
https://www.ebay.com/sch/i.html?_fr...w=cup+holder+insert+flaps+2002+Tahoe&_sacat=0
Last edited:
Ilikemtb999
Full Access Member
I was looking for new flaps and the little rubber pads that sit in the bottom, was just cheaper to buy an entire cup holder assembly for like $8 off eBay
HiHoeSilver
Away!
Did you yank the cupholder out and look down in the hole? I found one of mine in the abyss under there.
OP
OP
SnowDrifter
Full Access Member
Good idea
Could always go old school and get some of these!
A couple of those standing up in the center console would get in the way. LOL
Hang 'em on the door panel and enjoy the bath/shower when you close the door!
Ahh - Fond memories of my youth. Would have 7 of us in a old Chrysler New Yorker (3 in front/4 in back) and we would have 2 of these on each of the back doors. As the youngest, I was stuck up front between my parents and my drink was stuck between my legs. Many drinks were spilled in the back seat as doors got shut or elbows bumped stuff.
ks03
Fool Excess Member
- Joined
- May 3, 2019
- Posts
- 307
- Reaction score
- 299
https://www.tahoeyukonforum.com/threads/cup-holder-mod.101027/page-3
I cut the sides similar to ivin74, but not the back edge, so mine doesn’t close. no screws going down, just some 3m tape on the front sides of the cups when i was ready for final install. Works well with a larger range of sizes than the original
I cut the sides similar to ivin74, but not the back edge, so mine doesn’t close. no screws going down, just some 3m tape on the front sides of the cups when i was ready for final install. Works well with a larger range of sizes than the original
