2025 Tahoe Homelink appears normal but not operating

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

kozzy45

TYF Newbie
Joined
Oct 9, 2024
Posts
24
Reaction score
3
I had the same issue with my 2025 Yukon Denali. The door opener just stopped working. I disconnected the battery for about 10 minutes, then hooked it back up. It started working again has been fine ever since, months now. Also, I find that just doing a quick tap on the home icon seems to work the best. Mine now works 90 percent of the time without a second tap.
 
OP
OP
F

Forevr2whls

TYF Newbie
Joined
Dec 29, 2024
Posts
11
Reaction score
5
What you may need to do is erase them or go through the procedure if they don’t show up and reprogram them.
Hello again my friend. I tried to erase the code. It won't allow that feature. The HomeLink indicator symbol will appear when I get within a block from our home but will not activate garage door. I can go through the steps, but no changes are taking place.
 

Big Mama

Full Access Member
Joined
Jul 21, 2015
Posts
3,881
Reaction score
2,500
Location
Virginia
I found this nugget on line. What caught my attention was tapping the icon 2-4 times. If that’s not it you can always to the factory reset but make sure you have any passwords saved for reinstalling.

 
OP
OP
F

Forevr2whls

TYF Newbie
Joined
Dec 29, 2024
Posts
11
Reaction score
5
Try locking the vehicle using the remote or the door lock switch - while inside the vehicle, then try the Homelink button?

On many GM vehicles, when the vehicle is locked (windows up or down), the Homelink button is disabled by the BCM. When the vehicle is unlocked, the Homelink button is enabled.
I will try that tonight and get back with finding. Thank you, 2024 White Taho! Everything is worth a try.
 
OP
OP
F

Forevr2whls

TYF Newbie
Joined
Dec 29, 2024
Posts
11
Reaction score
5
Hello all, I have tried all variations and no success. Last week the dash instructed us to turn off truck for an update and stay away from vehicle at least 15 minutes. We stayed away an hour; I had high hopes but no changes on the operation of HomeLink. I will eventually return to dealership for diagnostic on the unit although not happy about it. Thank you all for your suggestions.
 
OP
OP
F

Forevr2whls

TYF Newbie
Joined
Dec 29, 2024
Posts
11
Reaction score
5
I would like to disconnect the battery and try what

kozzy45 suggested but read something online that once a battery is replaced/disconnected the dealership often has to reprogram other items to work properly. Anyone have thoughts on that? Thank you.​

 

Big Mama

Full Access Member
Joined
Jul 21, 2015
Posts
3,881
Reaction score
2,500
Location
Virginia
From what I understand a short disconnection is ok. Have you considered pulling the fuse instead? There’s also a factory reset option in your infotainment system. I’m not sure if it resets homelink but I set up mine to operate the garage doors when I’m close by from there.
 
OP
OP
F

Forevr2whls

TYF Newbie
Joined
Dec 29, 2024
Posts
11
Reaction score
5
Thank you Big Mama! I will give it a try, sounds like a great start before heading an hour to dealership and leave the vehicle for a week or so until they can get to it. I'm told they have their hand full of other issues right now.
 

dws1977

TYF Newbie
Joined
Jul 27, 2012
Posts
6
Reaction score
3
disconnect the negative on the battery for 10min then reconnect it. it worked for me on my '25 Escalade. 1/2 of my programmed remotes would work, half wouldn't. The dealer ordered the replacement module (on backorder) so I tried the battery trick and it worked.
 

Scarey

Full Access Member
Joined
Oct 15, 2024
Posts
308
Reaction score
269
‘25 high Country. Remote buttons stopped working after an ota update. Disconnected the negative, the easy one where it attaches to the frame, kind of a thumb screw next to the battery box. Works like normal now.
 
Last edited:
OP
OP
F

Forevr2whls

TYF Newbie
Joined
Dec 29, 2024
Posts
11
Reaction score
5
Hello

Big Mama- dws1977-Scarey-kozzy45 and everyone for the assistance in resolving this issue! Thank you for the quick fix method! Worked like a charm! I found the thumb screw cap you identified, removed the negative battery cable, left driver's door open 10 minutes, the closed door and re-installed in reverse order. Once I started vehicle it prompted me to roll down passenger window and then roll down passenger window, Now the garage door opener function is fully operational. I would have taken vehicle to dealership but had negative response.

I called to make appointment for this and the humming in headlight, the service writer was rude from the beginning, I felt intimidated. He said they do nothing about garage door opener function on screen without GM Headquarters approval which I would need to get first. Also first come first served, no appointments, then wait 48 or more hours for them to get vehicle to tech for diagnoses. Then wait for call from advisor. I will be writing a letter to the owners of dealership as I had praised them on many platforms, the have always responded and thanked me. Other than these two inconveniences we love the vehicle, oil/filter changed at 1K-3K-6K-10K. I will be getting transmission fluid change around 20K miles.
 
Last edited by a moderator:

Forum statistics

Threads
138,037
Posts
1,997,586
Members
102,974
Latest member
kikeap
Back
Top