thehoe92 Lowered 3/5

[clean454]

let put them in in the morning
what time are u getting up?

and ill look and see if we need to use
the factory mounts
or the extenders

 

[thehoe92]

I'll wake up early early to get them in since I have a meeting at 10

 

[clean454]

what u have to be at work at 10????//
well u wanna get the shocks in before the meeting or after?

 

[thehoe92]

meeting from 10-11 and work from 4-8

either way works for me

I'm thinking do it before that way I can ride around on them for a little bit

 

[clean454]

ok what time like 8?

my house?

 

[89 chevy]

Did the box weigh yours down to 30.5? Or what else did you do to lower it?

 

[thehoe92]

box was in when it was 31.5

 

[clean454]

dude will i finnaly tell these people u bagged ur shit already! damn
aired out hes 26.5ish

 

[thehoe92]

---------- Post added at 01:12 AM ---------- Previous post was at 12:26 AM ----------

stock?

not stock!

 

[Modded]

Damn that ** is nasty low, my lowest ground-fender measure is 33.75 haha, 3.25" from you, too bad the NNBS Tahoe cannot go lower that 32" without bags!

 

[89 chevy]

What bags did you go with?

---------- Post added at 10:52 AM ---------- Previous post was at 10:46 AM ----------

Did you cnotch it too? Because the way mine sits, I only have 3in of travel before the axle hits the frame.

 

[clean454]

did u cut out ur bump stop bracket?

 

[Modded]

Oh so it is baggEd, I knew it haha!

 

[89 chevy]

Yes Clean95

 

[thehoe92]

lmao! its not bagged clean95 is ****** with you guys

 

[Max]

You need to section 3/8"-1/2" out of your track bar now.

 

[thehoe92]

do explain max

we've got like 3 days left of mods I need some more to add to the list

 

[Max]

Your panhard bar is pushing the one side of your truck farther over than the other side, removing a small amount of material from the middle of the panhard (track) bar and re-welding the bar will pull the axle back to center between the frame.

 

[clean454]

heres a update!
rear bumper

up front

 

[thehoe92]

wheres the tape measure when you need one?!