Power running boards

[Upholsteryman]

2015 Yukon Denali power board stays out. When I shut door it tries to go in but only about 1/2” then goes back out. Acts like it thinks door is open.

 

[wjburken]

2015 Yukon Denali power board stays out. When I shut door it tries to go in but only about 1/2” then goes back out. Acts like it thinks door is open.

Very likely you have a hinge assembly binding and the motor is hitting its torque limit. This can be caused by dirt and grit building up in the pivot points.

 

[Upholsteryman]

I sprayed silicone wd 40 on all moving parts. Can I disassemble them and clean them?

 

[wjburken]

I sprayed silicone wd 40 on all moving parts. Can I disassemble them and clean them?

If you “help” it by closing the door and lifting with your foot can you make it close?

 

[Upholsteryman]

If you “help” it by closing the door and lifting with your foot can you make it close?

No

 

[Upholsteryman]

No

I’ve used my hands and it will not budge any farther

 

[wjburken]

I’ve used my hands and it will not budge any farther

Might have a hinge bound up due to mis-alignment. Might try and loosen the mounting bolts on them a little and see if that helps.

 

[Upholsteryman]

Might have a hinge bound up due to mis-alignment. Might try and loosen the mounting bolts on them a little and see if that helps.

Ty

 

[Upholsteryman]

Ty

I checked everything and after lubing it up, and I guess sitting a while it will let me push it up in , then it forces itself back out

 

[Upholsteryman]

OK now that everything is lubed up I can push it in with my hands and it’ll stay in but when I open the door it opens back up when I shut the door. It won’t go back in like it’s hung up but I can help it with my hands every time and was trying to keep doing it to see if it would eventually work correctly. Do you think it could be a motor?