Black2012z71
TYF Newbie
I have 2012 Tahoe z71 and when trying to open my hood in this cold Chicago weather the plastic broke. I haven’t been able to find a part# has anybody in here replaced it yet?
Interior hood Release latch
- Thread starter Black2012z71
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Black2012z71
TYF Newbie
Thank you very much!! So the whole cable has to be replaced too? The plastic piece is what broke, I saw that they sell it for the early 2000s model? Thank you again for that quick response
No. There’s a slot for the cable to be slid out of the handle, but I haven’t seen the handle sold without the cable.
Might still be able to just swap the handle but the old one is 12 years old. I would do the whole thing.
Black2012z71
TYF Newbie
Ok makes sense, thank you again
going to be a lot easier to just have someone hold the hood latch open and just change the handle inside, holding the latch open allows you to disconnect the cable easily.
PopoPackage2011
Member
- Joined
- Oct 29, 2023
- Posts
- 57
- Reaction score
- 56
Whats your diagnosis on this latch situation? Ice cold winter up north, went to pop the hood to see where my evap solenoid is (chasing down a P0496) and the hood lever was hard to pull, after finessing it the hood popped open. Went to close it and it wont fully latch. The bead at the end of the wire at the handle came loose, no plastic seemed broken on handle or anything screwed up at latch/spring. However there is no tension. What do you think? Latch stuck or snapped cable?
Really hard to say you just kind of have to take a closer look at the latch and the spring and cable
PopoPackage2011
Member
- Joined
- Oct 29, 2023
- Posts
- 57
- Reaction score
- 56
Spring on latch has strong tension. Just too tight to push down all the way into fully latched position
Lube up the latch and adjust if needed. Old cable with frozen inside the conduit.
maybe the latch is fubar, have you been in a accident? does it look bent anywhere? it should latch easily.
Black2012z71
TYF Newbie
Yeah I was going to just the change plastic part, but seems like the plastic piece isn’t sold by itself
How often do these handles fail? Would it be worthwhile to keep one on hand during road trips? I suppose if it came to it, a Vise-Grip levering against something else would work.
for as little as it comes up on here it's not very common but can happen, I think I have seen a handful of post's since 2017
Do search for hood release handle. It looks like you can get just that part for under $20.
