east302
Latest activity Postings About
-
-
Even though it says on the box that it is not for GM throttle body systems? I have that same kit for use on a different car and... -
east302 replied to the thread [SOLVED] Recommend Fuel Pressure Tester?.Good deal, glad you got it sorted out. As for the TBI on the box, technically ours had the central fuel injection versus TBI on 95 and...
-
east302 replied to the thread [SOLVED] Recommend Fuel Pressure Tester?.I’ve had this one for maybe ten years, but it has the threaded connector for the schrader valve.
-
-
east302 replied to the thread Heater Not Blowing Hot Like It Used To.What are the temperatures of the two hoses before and after the valve? Hoses number 1, 10, 16 and 18 in the image below… 10 and 18...
-
-
Do you have spark? #7 is not near #1 dist terminal. I don't know why you changed the dist. did you try putting the original...
-
You also need to be sure your scanner can read cam/crank correlation in degrees. Test at above 1000rpm steady. set to 0+-1 degree. In...
-
east302 replied to the thread 1996 GMC YUKON MISFIRE.Adding to the above, when were the intake gaskets last replaced?
-
Um....before bringing out the "jump to conclusions mat" I'd do some basic checks. 1. Coolant level - checked cold and after several...
-
Let's put the wallet away and start diagnosing. You changed a lot of parts, was there any reason for changing or just guessing? You...
-
White smoke is fuel. check fuel pressure at several rpm ranges while driving if possible (6 foot hose under wiper blade), as well as key...
-
east302 replied to the thread 95 Yukon Suburban drivers door handle.Rockauto sells the GM door handles.
-
-
east302 replied to the thread Hinge pins.......and more.It’s been a couple of years, but I did one on a 2008 and put a socket over the zerk fitting and tapped it up. I don’t remember it being...
-
east302 replied to the thread Hinge pins.......and more.Here’s the Cunningham part… https://cunninghammachine.com/heavy-duty-chevrolet-gmc-88-98-truck-door-pin-rollers/ It works well and...
-
Done a few, Cunningham makes good pins/bushings and a replacement roller. Dorman makes a roller replacement which is not high quality...
-
Any leak is no good. That thermostat uses a rubber seal around it and no gasket. Coolant sensor only reports info, can't make heat. You...
-
-
Loading…
-
Loading…
Forum statistics
Latest posts
-
-
-
Transmission Rebuild, Collapsed Lifter Debacle - Opinions Needed
- Latest: Bigburb3500
-
-
