ThomasKelly1952
TYF Newbie
Well just got a 2004 Yukon and still hadn't worked out the locking in DIC(sic). So when I went to open the liftgate, it broke in my hand since it was still locked. It didn't break right off but just seemed like one side.
On looking at various you tube videos, I just needed to drill a hole from the inside and put a screwdriver in the hole and turn and then it would finally open. I forgot to say that it is stuck closed. These holes (3) do not work. I am in a real pickle since I don't know where to go from here.
Should I try peeling off the frame around the handle and then see what I should do from there?
On looking at various you tube videos, I just needed to drill a hole from the inside and put a screwdriver in the hole and turn and then it would finally open. I forgot to say that it is stuck closed. These holes (3) do not work. I am in a real pickle since I don't know where to go from here.
Should I try peeling off the frame around the handle and then see what I should do from there?