Hey everyone!...Newbie here, so any help is appreciated.
I have an '03 Yukon with intermittent windshield wiper problems. They work fine when on high, but when the timer delay thing is active, then the blades either stop in the middle of the window until the next cycle of the delay timer cycles through; or it the blades studder through their range of motion.
I originally thought it was just a motor issue...but replaced the motor and the problem persists (however slightly different)
Any thoughts?
could it be the control module? if so, where is this located?
David
I have an '03 Yukon with intermittent windshield wiper problems. They work fine when on high, but when the timer delay thing is active, then the blades either stop in the middle of the window until the next cycle of the delay timer cycles through; or it the blades studder through their range of motion.
I originally thought it was just a motor issue...but replaced the motor and the problem persists (however slightly different)
Any thoughts?
could it be the control module? if so, where is this located?
David