Recent content by Ronzxcvb
-
Transmission cooling lines
Thanks for the help I ordered some from Auto Zone they said would be in today. But when I went into town to pick them up now they wont be in until Tuesday and I need the truck on Saturday. I put on a add on cooler years back that used rubber lines so thought I could just patch it up with some...- Ronzxcvb
- Post #6
- Forum: Engine & Drivetrain
-
Transmission cooling lines
One of my transmission cooling lines has a leak Can I cut out the bad section and replace with a piece of fuel line?- Ronzxcvb
- Thread
- Replies: 11
- Forum: Engine & Drivetrain
-
Self alignment
after replacing a tie rod you need to adjust toe so if done properly I think you would be ok doing it yourself I would also take tire condition into consideration- Ronzxcvb
- Post #16
- Forum: Street Suspension
-
Does the gas return lines have to be replaced with steel?
I want to thank everyone for there input I fixed it with rubber fuel line I did contemplate using steel even after I started but that would have required me to drop the gas tank And I have a bad back so my Yukon would probably be still sitting on the stands 2 weeks from now had I went that...- Ronzxcvb
- Post #11
- Forum: Engine & Drivetrain
-
upper control arm ball joint boot
I cant find any place that sells them or even has a part # Or carries boots in stock for another vehicle I should have worded my posts a little better And without getting a response here it's obvious that I am hoping to buy something that just isn't sold I'm going to get a new ball joint and...- Ronzxcvb
- Post #5
- Forum: Street Suspension
-
upper control arm ball joint boot
I spent a few hours looking online and called all the local parts stores to see if they had anything in stock that might fit but they all said they are special order only and don't carry any in stock I know I have heard about replacing them even ran across some for other vehicles thought I saw...- Ronzxcvb
- Post #3
- Forum: Street Suspension
-
upper control arm ball joint boot
I replaced my upper control arms about 7 months ago and just noticed that one has a tear in the boot grease don't look like any dirt got in yet so think that replacing the boot would work I don't want to have to get another alignment so was thinking that replacing the boot would be less likely...- Ronzxcvb
- Thread
- Replies: 5
- Forum: Street Suspension
-
Does the gas return lines have to be replaced with steel?
Was hoping rubber would be ok I never worked on a return line and don't know if it has higher pressure so steel would be needed once you have to touch the connections on rusted steel lines I think your better to just replace everything from the get go and splicing in new steel gas line would be...- Ronzxcvb
- Post #4
- Forum: Engine & Drivetrain
-
Does the gas return lines have to be replaced with steel?
One rusted out on my 2000 Yukon and was hoping I could replace it with some 5/16 gas line- Ronzxcvb
- Thread
- Replies: 16
- Forum: Engine & Drivetrain
-
Fixed lift gate handle
Same thing happened to mine yesterday Thank you for the picture will make fixing it easier -
-
Mounting Bolts Stuck
Pb blaster is available at alot of places but just needs to be a penetrating oil merry christmas- Ronzxcvb
- Post #5
- Forum: Engine & Drivetrain
-
fault code P0453 13 hour drive?
Made it with no real problems Merry christmas- Ronzxcvb
- Post #4
- Forum: Engine & Drivetrain
-
Spill/leak after fluid change???
No something. Is wrong and needs to be fixed right away- Ronzxcvb
- Post #2
- Forum: Engine & Drivetrain
-
Fuel pump codes
did you enter your vin at a dealer site like GM parts direct to get the proper part #? Then enter that in the search field for fuel pumps at rock auto that's the only thing I can think of to help- Ronzxcvb
- Post #6
- Forum: Engine & Drivetrain
