mikez71's latest activity
-
White only covers white….. Be patient with the coats……. -
mikez71 replied to the thread EVAP Charcoal Canister Removal Modification.I do see a temp enable setting for purge.. BUT only for closed loop.. Likely the ECM will open purge at startup for emissions/gas cap...
-
-
mikez71 reacted to kbuskill's post in the thread EVAP Charcoal Canister Removal Modification with
Like.
I'm not certain that you can turn the purge valve off in the tune, perse. You can, however, tell the ECU to ignore all codes associated... -
mikez71 reacted to kbuskill's post in the thread EVAP Charcoal Canister Removal Modification with Like.
No reason to vent it as there is already a vent solenoid on the tank. You could just cap it off under the hood where you disconnect it...
-
mikez71 replied to the thread Best way to stop flaking white paint?.I'm slow to paint!.. I just primered some yesterday.. Had an issue with first primer coat too wet, and it rippled along some of the...
-
-
Back in the ’80’s, GM was slow to finish paint the white, …when the primer had already cured. Hence all the white paint peeling.
-
Looks the the first version is ~24 long extended, 126lbs of force. Second version is 24.6" extended, and 150lbs of force.. My truck...
-
mikez71 reacted to lowh07's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Sad.
This was right after removing the wrap yesterday and it looked much better than I thought it would. If it wasn’t bleeding it would’ve...
-
mikez71 reacted to Sir_Hiro's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Like.
Tried to Replace the rear AC lines since thats why I really bought the truck. Well lines are fused to the rear core and I'm not about to...
-
Definitely a good thing to check, thanks. There is plenty of clearance, tho. I put all six crank bolts in the flex plate and then...
-
My Escalade electric boards quit working, had to remove them clean the hinges, added grease zerks to each hinge and got them working...
-
I followed the AMP research PDF and routed the wiring harness across the top. I followed the body harness down the driver side and the...
-
mikez71 replied to the thread Sunroof air deflector replacement parts.Front clips may not be removeable..The pin has a groove that the plastic fits in.. Even if you get the plastic tab out of the groove...
-
-
If you bring a battery with you, a drill battery will work.
-
Water gets in to the cowling area thru the top vented area and IIRC, that is a flap from the end of the drain channel. Look at the other...
