I’m only at 170k on my 02 so I guess I won’t worry about it.
What did you do to your NBS GMT800 Tahoe/Yukon Today?
- Thread starter vwbeaner
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Tonyrodz
Resident Resident
Just changed mine on my 05 Express, only has 149,000 on it. Fried it! I could smell it when it went.I’m only at 170k on my 02 so I guess I won’t worry about it.
David Staines
Member
I dropped in a Sony XAV-AX5000 radio. I had one in my previous Tahoe and really liked it. The second time you do it is WAY easier... especially when you have a heat gun and solder/shrink wrap for the cable adapter. I had the whole thing done in less than an hour. I also found the correct bow-tie for my HD grille. Lastly... I finally had the AC system completely re-done.
Tonyrodz
Resident Resident
Front end looks good.
BowtieBeezy
Member
Which wires did you tap into?
Woodblocker55
Full Access Member
- Joined
- Apr 13, 2019
- Posts
- 673
- Reaction score
- 422
2002 Chev suburban LT fixed ground and turned around and seen another to the rear in the rust camo ya battery charger even charged more crazy ...
Sent from my LGL722DL using Tapatalk
Sent from my LGL722DL using Tapatalk
druiddonn
Full Access Member
- Joined
- Oct 3, 2015
- Posts
- 112
- Reaction score
- 128
I tapped into the fuse box between the brake pedal and emergency brake I can't find the photo of it right now but I simply used a spade and slid it into the connection next to the existing connection I think it was an orange wire and then I grounded it to the bar that's part of the crash that come under the dash
NoReverseYukon
Full Access Member
After much f-ing around, I got those 2-piece dust shields behind the back rotors. Beats pulling the axles, but they're rubbing. I'll drive it around the block to check where, then do some bending.
Washed her off after the snow earlier this week. Halfway detailed, cleaned air filter, so had to touch up a little under the hood.
Washed her off after the snow earlier this week. Halfway detailed, cleaned air filter, so had to touch up a little under the hood.
I am so shamed when I see this! LOL
Lol. It’s only skin deep. The valve covers are shamefully filthy.
Looks good to me Sam.
Waaay better than mine that sat outside for a couple of months while her garage stall was the deck workshop. Guess there are no more excuses now.
Get busy! [emoji16][emoji106][emoji631] the deck looked to be worth it!
Now, now, @Sam Harris I'd have cleaned her up if I didn't have to go to UPull to get YOU these fans today:
Donor was a 2005 Hoe that came in last week. Not wrecked on the front end but some stuff was already gone. I put 12v to each fan and they're good!
I got some other stuff I needed which is really why I went. I saw these and couldn't pass them up. This here is a bonus at $32 + the governor's take.
Donor was a 2005 Hoe that came in last week. Not wrecked on the front end but some stuff was already gone. I put 12v to each fan and they're good!
I got some other stuff I needed which is really why I went. I saw these and couldn't pass them up. This here is a bonus at $32 + the governor's take.
Tonyrodz
Resident Resident
Nice. Grabbed the harness too?
I didn't. Wasn't quite prepared with enough tools.
Ahh hell yeah!! Thanks Fless! You da man!!
Double tap
I have one already. Giggity!!
Similar threads
