Drgnblood
F%ck Douchebagistan!
FML....i installed my servo today...took me a few hours between some other stuff i had going on.....watched the videos over and over including today to make sure everything was installed correctly... so i went for a drive in the neighborhood and it wasnt shifting correctly so i drove back to the house very slowly and noticed it was smoking.....pulled in the garage and jacked it up....fluid everywhere....too hot to touch anything now.....what should i do...or rather what did i do wrong....the snap link ring was a b#*$ to put back on...im hoping that that is whats wrong.....any help is greatly appreciated
just an update...pulled the heat shield and the snaplink fell out so i think i didnt get it in there enough........thats a tight area anyways....can someone tell me the best way to insure i have it in there correctly....and i heard a little metal on metal when it was limping back....so should i put in the second vette servo....bought two by mistake....lol
just an update...pulled the heat shield and the snaplink fell out so i think i didnt get it in there enough........thats a tight area anyways....can someone tell me the best way to insure i have it in there correctly....and i heard a little metal on metal when it was limping back....so should i put in the second vette servo....bought two by mistake....lol
Last edited: