Stabilirak Off, Traction Control Off, Engine Light On, Into limp Mode - In that order, while driving

[Joseph Garcia]

I ran the voltage drop test, and I have a 0.23 volt drop on the negative battery cable to the engine block and a 0.01 voltage drop on the positive battery cable to the main fuse block. As such, the negative battery cable is above the maximum threshold of 0.20 volts, so I will replace all battery cables at the same time.

I took the truck out for a 15 mile drive and a 10 mile drive on local streets, respectively, and I had no DIC warnings. After both runs, I checked for trouble codes, and there were none.

So............. I 'think' that I am in the clear, but it will take a lot more miles of trouble code free driving, before I can fully trust the truck again.

After the replacement battery cables are in place, and I have no new trouble codes, then I will label this issue and thread as SOLVED. At this point, I believe that the source of my issue was either a bad ground #300, or the chafed wire on the transmission wire cluster.

 

[PG01]

Good work Joe.
You did well diag, troubleshooting and fixing.

 

[Joseph Garcia]

I put another 20 miles on the truck yesterday, and I had no trouble codes when I returned and hooked up the scanner. Building trust.....

 

[Doubeleive]

for future reference that "bcm ground" problem was only noted on some of the early k2 pickups, apparently the production line was a little over zealous with the glue and it caused some grounding problems for the bcm, as far as I know it has never been noted for the earlier gen vehicles.

 

[Joseph Garcia]

for future reference that "bcm ground" problem was only noted on some of the early k2 pickups, apparently the production line was a little over zealous with the glue and it caused some grounding problems for the bcm, as far as I know it has never been noted for the earlier gen vehicles.

Good to know, as I really did not want to get into the dash disassembly work.

 

[JD12]

I ran the voltage drop test, and I have a 0.23 volt drop on the negative battery cable to the engine block and a 0.01 voltage drop on the positive battery cable to the main fuse block. As such, the negative battery cable is above the maximum threshold of 0.20 volts, so I will replace all battery cables at the same time.

I took the truck out for a 15 mile drive and a 10 mile drive on local streets, respectively, and I had no DIC warnings. After both runs, I checked for trouble codes, and there were none.

So............. I 'think' that I am in the clear, but it will take a lot more miles of trouble code free driving, before I can fully trust the truck again.

After the replacement battery cables are in place, and I have no new trouble codes, then I will label this issue and thread as SOLVED. At this point, I believe that the source of my issue was either a bad ground #300, or the chafed wire on the transmission wire cluster.

I had the same issue on the same year Xl Denali, and cleaning the chassis ground under the driver door did the trick. You can get to the ground under the dash by the driver A pilar without much dash disassembly…without damaging clips, just work smart and carefully. Start by removing the vent left of the cluster.