Rear subwoofer tapped into for Line Out Converter

[Yukon Ron]

If I wire up a line out converter off the factory subwoofer in the back, am I still using an amped signal from the stock system to send to my aftermarket amp? Anybody know where the factory amp is located for the subwoofer??

 

[NoPh33rRaCiNg]

If I wire up a line out converter off the factory subwoofer in the back, am I still using an amped signal from the stock system to send to my aftermarket amp? Anybody know where the factory amp is located for the subwoofer??

It should work. I have a buddy that tapped into factory sub in a acura TL and it worked just fine. I believe the amp is in the center console? I know the factory amp for the door speakers is behind the glove box.

 

[Yukon Ron]

word..I hope so....I wanna keep my stock deck so that my shit doesn't get stolen. I'm just worried about getting any feed back from having it double amped but if it doesn't work, I'll just jump in front of the amp...hope it's under the center console.

 

[blueflamed03]

already bought the woofer and amp?

 

[redemn93]

thats what i did for my single 12. works just fine.

 

[blueflamed03]

put one of these in my sons trunk car...holy moly it does pound for 400 watts, simple power, ground and splice into wire for signal.

 

[Yukon Ron]

thats what i did for my single 12. works just fine.

yea it works great! I just tapped into the accessory for remote, tapped into the incoming speaker line to the sub and ran rca's direct to the amp..only had to hide the 4 guage and remote wires in the door trim which made it nice.

I have 2 Rockford P1 12's and a 760 Pioneer pushing them...weird thing is that the gain on my amp is turned wayy down and it still bumps hard...P1's suck though, I might get some different ones soon...but it hits good for a stock deck...just sucks that I don't have any bass controls...

 

[Denalilover]

What color speaker wires did u tap into,,

 

[skaffy03]

Just pull the cup holders out and tap into the amp wires there.


Sent from my iPhone using Tapatalk

 

[YukonXL04]

Make sure to tap into the wires before the amp. The factory amp has crossovers built in. You will want to bypass those by tapping into the input for the amp.

 

[Denalilover]

I have a 2002,so I know my amp is in the back,
I already took off the rear panel,but what color wires
Should I tap into??any body have a diagram or something???

 

[Chevy305]

So it works just pulling the wires off of the factory sub and plugging them into a single 12"?

Or do I need to install an amp too? And if so do I have to connect it before or after the factory sub amp?

Sent from my Galaxy "LS3"