Installing my new AVIC-X930BT tonight, a couple of questions!

[ChrisAU]

I have on hand all of the wiring tools I need, and I've done a SWI-PS before, so I'm good there.

Two questions I have though are this:

Where/how do I route the GPS wire?

Where/how do I route the Bluetooth mic?

I have ideas I'd just like to know how others have done it.

I'm stoked about putting it in.

 

[2007tahoe]

I have on hand all of the wiring tools I need, and I've done a SWI-PS before, so I'm good there.

Two questions I have though are this:

Where/how do I route the GPS wire?

Where/how do I route the Bluetooth mic?

I have ideas I'd just like to know how others have done it.

I'm stoked about putting it in.

Yea everyone is going to have there own way on this topic.
gps wire - I routed mine over the pedals to the fusebox eccess than mounted the sensor in the dash infront of the driver. The big forward part of your dash that touches the windshield is just held on by clips, just pull it up to get access under it. I did this for a temp install but I have never lost signal and usually have a decent signal so I just left it there. I might run it outside someday if I am feeling bored.
bluetooth mic - i ran it behind the driver a piller and clipped it in the corner of the windshield and piller. It works great for the driver but the passenger has to talk a little louder for them to here you. I left it there because the headunit only connects to one phone anyway (usually the drivers). You could always run the wire in the roof and connect it to the rearview mirror if that is a problem.

 

[Fearz]

^ did you both lose on star support?

 

[ChrisAU]

Yes, I never had OnStar and dont now. Well actually if I hold down the speak button it does say Welcome To OnStar, so maybe it can be cut on?