Gauge Pods

[Tonyrodz]

Do they make any gauge pods for our trucks? I've seen a few cheesy ones nothing really nice. Maybe a nice pillar pod or something.

 

[FamilyTruckster]

for starters...
i'm pretty sure there's a steering column pod as well... might have to search under silverado etc. but it should be out there...
www.autometer.com
http://www.autometer.com/mounting-solutions/direct-fit.html

 

[Tonyrodz]

Nice! Thank you .

 

[FamilyTruckster]

any time... also, nothing is "impossible", you can always go the custom route... ive seen people install in the overhead compartment (interior lights/homelink/sunroof ctrl panel/sunglass holder area even in an AC vent or that useless pocket where the 4x4 switch would go), or if you have the center console/bucket seat setup i made this on my 2004 SS...

View media item 25138
View media item 25132
View media item 25139
View media item 25126

 

[FamilyTruckster]

looks like they do have a column pod for 03 as well...

http://www.jegs.com/i/Auto+Meter/10...fkhZDU_m5i04YyJHdSX--bI1HXPc6j5Rd4aAnUE8P8HAQ

 

[FamilyTruckster]

more custom etc pics/ideas....

 

[FamilyTruckster]

and.... finally.... my personal favorite... i will leave you with this....

 

[sumo]

This is what I use. I'm using a wideband and boost gauge in one

 

[Tonyrodz]

any time... also, nothing is "impossible", you can always go the custom route... ive seen people install in the overhead compartment (interior lights/homelink/sunroof ctrl panel/sunglass holder area even in an AC vent or that useless pocket where the 4x4 switch would go), or if you have the center console/bucket seat setup i made this on my 2004 SS...

View media item 25138
View media item 25132
View media item 25139
View media item 25126

Looks great ! Damn good work . I still have time to figure out what I'd like to do. I bought new replacement gauges for my GN, so I was trying to figure out where to put the old gauges in the Tahoe. A-pillar, steering column. I don't have the center console, so I was thinking somewhere in a cubby or something custom, but not in your face, like the pillar and column gauges. You have some really good ideas.

 

[adriver]

NOT AFFILIATED
https://www.performancetrucks.net/forums/gm-parts-classifieds-23/99-07-gauge-pod-554493/

3D printed gauge pod, available in 2 5/8" and 2 1/16". Comes with new clips installed. The gauges are angled 10 degrees out and five degrees upward for better visibility. $35 shipped each.

 

[00'BlueSteel]

There’s the one for under the rear view mirror, I posted in my thread a while back.