Disclaimer: Links on this page pointing
to Amazon, eBay and other sites may include affiliate code. If you click them and
make a purchase, we may earn a small commission.
no you don't have to pull the distributor just unbolt the two nuts holding the fuel lines into the top of the plastic intake. there is also a 13mm bolt holding down the fuel lines beside the distributor (semi hard to get to). Then pull the harness out of the top,then all of the nuts and bolts holding the upper plastic plenum down-also a couple of sensors etc...then you will see the injector spider system....
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.