-
-
Iintergalactron replied to the thread Gotta do a Rebuild, Gonna Upgrade Too.And finally the push rods. Tips look great. Some have some buildup on the rod. Unfortunately I don't know which ones came from where.
-
-
Iintergalactron replied to the thread Gotta do a Rebuild, Gonna Upgrade Too.Lifters. Aside from the failed AFM lifter pictured previously, there's only a little bit of scoring on the rollers. All rollers ran smooth.
-
-
Iintergalactron replied to the thread Gotta do a Rebuild, Gonna Upgrade Too.Cam. #7 had the failed lifter, but I can't find any damage from that. Cam is oriented with #1 at the top, #8 at the bottom. First...
-
-
Iintergalactron replied to the thread Gotta do a Rebuild, Gonna Upgrade Too.Rod Bearings. Some visual wear, but I couldn't really feel any of it.
-
-
Iintergalactron replied to the thread Gotta do a Rebuild, Gonna Upgrade Too.Piston Rings. Look pretty dirty in this pic, but they were free on the pistons. Probably picked up some of the dirt from the box they...
-
-
Iintergalactron replied to the thread Gotta do a Rebuild, Gonna Upgrade Too.Next up: Main bearings. Not sure why the thrust bearing broke. For the most part these look really good. Only a couple of scratches...
-
-
Iintergalactron replied to the thread Gotta do a Rebuild, Gonna Upgrade Too.I was cleaning in the garage last nite and started digging thru the bits and pieces from my rebuild last summer. Here's the oil pump...
-
-
Iintergalactron replied to the thread K&N Oil Seperator (Catch Can).I installed one on my wife's A6. Collected a lot of goop...
-
IThought about adding a Catch Can to my 5.3 powered 2020 Tahoe over the years, but never did it. A couple months ago, I noticed K&N came...
-
IThere are also two paths to consider: pull the motor, or work on it with the motor in place. If you pull the motor, it’s a lot easier...
-
Iintergalactron replied to the thread AFM DFM Conundrum.You could also consider lifting the body off the chassis. But that requires a lift that you can occupy for a while while you work on...
-
Iintergalactron replied to the thread AFM DFM Conundrum.If you're going to split a canned tuner with a buddy, make sure that it supports multiple vehicles.
-
Iintergalactron replied to the thread AFM DFM Conundrum.I've done a Gen 4 and am currently in the middle of doing my second Gen 5. The Gen 5's have been overhauls with the AFM deletes, so...
-
Iintergalactron replied to the thread AFM DFM Conundrum.If memory serves, to do a proper mechanical delete, you have to replace the cam. The AFM lobes are different than the non-AFM lobes...
-
Iintergalactron replied to the thread Spark plugs.It's extra work, but pull the wheel and fender liner. Then you get excellent access to the #8 plug, not to mention the others on that side.
-
-
Loading…
-
Loading…
