iwaslowr
ɹǝqɯǝɯ ɹoıuǝs
Has anyone installed them? Did you really need a press to remove the stockers and re-install these?
Last edited:
Bell Tech 4955 Front Camber Bushings
- Thread starter iwaslowr
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Modded
That Guy
- Joined
- May 3, 2009
- Posts
- 6,942
- Reaction score
- 109
There def. needed so the car can align to stock standards....hard to install so don't try on your own!
mdtahoe
Full Access Member
- Joined
- May 2, 2009
- Posts
- 162
- Reaction score
- 0
How low are you going?
OP
OP
iwaslowr
ɹǝqɯǝɯ ɹoıuǝs
Not sure yet... 3/5 is the current goal...
road1will
pretty pretty good
I havent done it, but ya, you'll definitely need a press.
Modded
That Guy
- Joined
- May 3, 2009
- Posts
- 6,942
- Reaction score
- 109
No way a 3/5 is happenning on that Yukon with 26s w/o alot of mods.....I've seen people not even able to make that with 24s, talklless of 26s!
2/4 is the lowest it will probably go!
2/4 is the lowest it will probably go!
