Yes man, I laugh too.Thank God...
![]()
[emoji23] Remember this is not an airplane, but we are getting close to being.
Sent from my Pixel 2 XL using Tapatalk
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Yes man, I laugh too.Thank God...
![]()
2020’s are hovercraftsYes man, I laugh too.
[emoji23] Remember this is not an airplane, but we are getting close to being.
Sent from my Pixel 2 XL using Tapatalk
Hold fast to dreams, for if dreams die, life is a broken-winged bird that cannot fly.2020’s are hovercrafts

New front air dam. Mrs LT1ZOB found the one curb that was too tall over the winter, so just waited out the crappy weather
View attachment 222082
which catch can is that?Installed this aluminum box in the 2nd battery tray and added a Texas emblem to the rear.View attachment 218649 View attachment 218650
can any one post a picture(s) of under the hood, I am trying to see how the battery ground cable is connected to the block and where the other end bolts to the frame at. I have the nmbs but I think I can use the ground cable from the 2015+
thanks, I am trying to see more towards the front of the engine where the ground wire attaches to the engine block, then there is another smaller cable that attaches to the frame on the passenger side somewhere the cable looks shorter than the one for nnbs's so just trying to make sure I can make it work, if nothing else I can go by the dealership tomorrow and poke my head under the hood of one on the lot.Sorry bud, these are not the best. I’m holding a flashlight with one hand and taking a pic with the other.
View attachment 222131 View attachment 222132 View attachment 222133
Did you get what you needed? Is it doable?thanks, I am trying to see more towards the front of the engine where the ground wire attaches to the engine block, then there is another smaller cable that attaches to the frame on the passenger side somewhere the cable looks shorter than the one for nnbs's so just trying to make sure I can make it work, if nothing else I can go by the dealership tomorrow and poke my head under the hood of one on the lot.
I couldn't see where it bolts on from the photos, but I poked my head under the hood of one in the parking lot at my kids school that was waiting for there kid to get out, didn't have my flashlight but it looks like it bolts on to the block down by the starter somewhere? and where it bolts to the frame I couldn't seeDid you get what you needed? Is it doable?
which catch can is that?
Good to hear, sorry took a ‘phone vaca’ while on vaca...
1475 miles, 23 hrs and 45 minutes, 70-75 the whole way and 23 hrs back home. Truck is at 7200 miles now. No issues.
View attachment 221737