livingez_123
Full Access Member
Why would you cover your vent?
What did you do to your NBS GMT800 Tahoe/Yukon Today?
- Thread starter vwbeaner
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Why would you cover your vent?
02 Burb
Full Access Member
It doesnt matter that much to me when i rarely use the ac or heater in california, air still comes out through the bottom tho. Also it was the only place that looked decent and would stay with some mounting tape.
M Hankel
Full Access Member
Played around with EFILive and tuned out the torque management from the auto-tragic trans.
The twin disk Monster clutch showed up today too.
Mike
The twin disk Monster clutch showed up today too.
Mike
Must be nice, here we can use the a/c in the a.m then come lunch have the heater on.
Big Buttons
The SS Burb
Lol on this side of TX I used the a/c for almost all of the winter...
Goodinblack
I Like Tacos
YukonXL04
The Riverboat
Ha... We use heat here all the time...
And summer time screw not using AC... Lol
And summer time screw not using AC... Lol
livingez_123
Full Access Member
I have be contemplating weather I should keep my Denali or try to find a 2500 YukonXL or Sierra that I would be happy with. today I came across a bunch of parts that I think will make my decision a bit easier. I found a complete 2500 rear diff from rotor to rotor and all cables, a 4L80E complete with driveline and converter, and flex plate. Complete front knuckles including the calipers, rotors, and lines. all of these parts have 75k on them. It would be a straight forward swap except for the rear diff, but that would just take some cutting and welding the 4 link brackets to it. In the end I would have my Denali with a better towing capacity and that is all I really wanted....except for more torque. I will think about it over the weekend.
Led interior conversion completed yesterday, also did the puddle lights and license plate.
Got my new to me Esky rack installed, great condition except for the rear cap bracket was warped....I had to use black silicone to fill the gap bc it wouldn't conform to the roof. Damn that silicone is messy to work with. Once it's dry, I'm going to clean it up a bit and maybe lightly sand it. There were a couple gaps where the weatherstrip meets the roof so I silicones those too, but I'm guessing water seeps under these racks and it's normal.
Got my new to me Esky rack installed, great condition except for the rear cap bracket was warped....I had to use black silicone to fill the gap bc it wouldn't conform to the roof. Damn that silicone is messy to work with. Once it's dry, I'm going to clean it up a bit and maybe lightly sand it. There were a couple gaps where the weatherstrip meets the roof so I silicones those too, but I'm guessing water seeps under these racks and it's normal.
Attachments
NCTyphoonKid
Full Access Member
Whoa! 300k?
I got lucky when I hit 150k....I started up one morning and it was exactly 150,000....glad I looked, otherwise I would have missed it.
NCTyphoonKid
Full Access Member
It had 294 when I replaced the knocking 5.3 but everything else is 300k planning on 5-600k+
The 'ER
Full Access Member
We welcome everyone! Minnesota is a great place to live! Even at -30 straight temp!
Damn right.....
The 'ER
Full Access Member
Yeah I know. And dont forget the season of Flooding!!
Similar threads
