1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
Last Activity:
May 12, 2021 at 2:52 AM
Feb 18, 2013
Likes Received:
Trophy Points:

Following 1

Followers 1

Sandy, OR

Share This Page


Full Access Member, from Sandy, OR

livingez_123 was last seen:
May 12, 2021 at 2:52 AM
    1. livingez_123
      After you pull your lower panel off (under the steering wheel) you will see the BCM. it has three plugs going to it. The plug on the right is blue, and that is the one you want. Looking at the plug from the back side of where the wires go into it, the bottom row, count from the left to the right. you want the #3 wire and the #5 wire. They are both gray. cut the wires back about 1 1/2" from the plug. Now with the two wires coming out of the plug, that is where you put the resistor, from one wire to the other. I cut small pieces of shrink tube and slide them over the wires first so after you soldier them you can put the shrink tube over them. The other two ends of the wires that go up into the harness, you can just tape them together out of the way. I hope this helps.
    2. boozer
      On the disable headlight mod I'm kinda confused on where to put the resistor. Just not sure on what to do with each wire, hook them back in. Idk. All I got is where the wires are. Can maybe you explain it in a little more detail for me please?
  • Loading...
  • Loading...
  • About

    Sandy, OR


    05 GMC Denali XL, Summit pro ls truck cam, ls6 lifters and springs, Melling oil pump and timing set, new King rod and main bearings, sealed power rings. More to come

    2001 GMC Denali XL, Volant cold air intake, True dual exhaust, Long tube headers, Air bags in the rear are gone and the Eibach springs in..... Gone to a new family to make more awesome memories.