Questions about lift.

[Cshayes2]

I currently have the CCM 2.5/1 leveling kit on my tahoe, and i believe it has settled to where it'll be permanently. I was curious if there are any further options short of a full lift to raise the front end a little to actually level the front or even a slight cali lean. PLEASE HELP

 

[Zed 71]

With a simple spacer kit I would not raise the front anymore unless your are only 2WD. If you raise it anymore I would be concerned about the CV angles.

It should only be ~0.5" or so higer in the rear. Do you have autoride?

IMO replace the rear spacer with a 1".

 

[Cshayes2]

With a simple spacer kit I would not raise the front anymore unless your are only 2WD. If you raise it anymore I would be concerned about the CV angles.

It should only be ~0.5" or so higer in the rear. Do you have autoride?

IMO replace the rear spacer with a 1".

It is just a 2wd I had no choice in the matter, found a good deal with low miles. It is about .5 inches off level i Just wanna slight cali lean. TBH

 

[Zed 71]

Your original post indicates 1.5" rear spacer and your sig shows 1" rear spacer.

In any case, since your are 2WD the front can be increased. Although I would look into this more because I do not know how that much lift (from spacers) will affect handling and durability. I would not add another spacer though (spacer on top of the CCM). Either try to find a 3" front spacer or change the struts to Bilstein 5100s which are adjustable (keep the CCM installed).

 

[yates ™]

How much higher you can go in the front will depend on how far your control arm is off the droop stop. They make a lower spacer but if all you want is lean and you are fine with the front height then just take the spacer out of the rear

 

[Cshayes2]

Your original post indicates 1.5" rear spacer and your sig shows 1" rear spacer.

In any case, since your are 2WD the front can be increased. Although I would look into this more because I do not know how that much lift (from spacers) will affect handling and durability. I would not add another spacer though (spacer on top of the CCM). Either try to find a 3" front spacer or change the struts to Bilstein 5100s which are adjustable (keep the CCM installed).

Yea, my original post was a typo, it is just 1" rear, which i do want to keep Yates, I want as tall as possible but i drive 200 miles on the highway every week or 2 and don't want to get 8 MPGs Did some looking around, Like the bilstein idea(seen a couple guys with what would be my setup if i did it) seems like a fairly cheap part, correct me if I'm wrong but its like $75? but how is it adjustable? and the things I've seen seem to just be the shock.

 

[Zed 71]

Only the front 5100s struts are adjustable by using the collar. Look at the Bilstien website.