Blower motor dont work on 1 & 2 speed.

[vosevichs]

So front blower motor is not working on 1 and 2 speed. Did a little searching here, read some post. Melted connector at resistor, Looks fine. Measured voltage at connector 12vdc yellow, speed1 - black. ground and 12vdc tan, speed2 - black ground. So switch good, connector looks good. Going to bring some clips for my meter and try to ohm out the resistor.

ANY SUGGESTIONS???

01 GMC YUKON XL, 5.3L

 

[Scottydoggs]

the resister goes bad. id start there.

 

[vosevichs]

the resister goes bad. id start there.

Resistor it was.

Sent from my SM-G900T using Tapatalk

 

[throwback2]

I have the same problem.I took off the panel and got #s on resistor and ordered on line. It should be here this week.Apparently a common problem.