2011 Yukon left and right blinkers stopped working

[Bob D]

Hello -

Left and right blinkers stopped working!

Fuses good, multi function works fine.....high beams and low beams work, hazards work, rear wiper works.

There is no blinker relay that I can find like the older GMC trucks.

Any help would be appreciated!

 

[gooffeyguy]

Did you check the fluid?

 

[Doubeleive]

this where you need a tech2 to troubleshoot, the switch may be bad but a tech2 would confirm, these do not have a blinker relay it's all internal to the bcm

 

[Bob D]

Did you check the fluid?

It's full, thanks!

 

[Bob D]

this where you need a tech2 to troubleshoot, the switch may be bad but a tech2 would confirm, these do not have a blinker relay it's all internal to the bcm

Thank You!

 

[BG1988]

Hello -

Left and right blinkers stopped working!

Fuses good, multi function works fine.....high beams and low beams work, hazards work, rear wiper works.

There is no blinker relay that I can find like the older GMC trucks.

Any help would be appreciated!

do you have power at the fuse?.. do you hear the clicking noise?

 

[Bob D]

do you have power at the fuse?.. do you hear the clicking noise?

Yes fuses are good, there is no clicking when you turn the blinkers on. when you turn the hazards on...the clicking is heard through the speakers.

 

[avalonandl]

Possible bad wire in steering column.

 

[Bob D]

Will check it out, Thanks

 

[Danny3737]

Did you check the fluid?

 

[Bob D]

Yes!

I have a case, bought it back in 1996 just before they banned it with R12!

 

[gooffeyguy]

The amount of people that I see that don't use their blinkers, you'd think that stuff is made of gold

2001 Yukon SLT
2012 Yukon Denali XL
2011 Yukon Denali RIP 5/20/18

 

[Fless]

Hard enough around here to get them to turn on their headlights before sunrise and after sunset. Seeing --or not seeing them -- too many these days.

 

[Bob D]

Great news people, I replaced the multi function switch and the blinkers work..... cost 25 bucks and took 20 minutes, FYI you do not have to take off the steering wheel on a 2011. 2 screws and 4 wire connections, easy!

The hardest part was pulling off the screwless bottom and top column covers and putting them back on!