Sorry for the extreme delay. Was the right front wheel bearing. On my way to work on Xmas eve night it finally gave out I live about 60mi north of my work. And it blew out about 15mi from my job. I was able to limp it to work, and ended up repairing it in the parking lot. Had to cut the old...
So I pulled into KFC to get lunch and all three warnings pop up on the DIC. I found one of the connections came off when I did the rear shocks. I haven’t checked those two connections yet. Going to shortly,
but what I want to know is this:
Is there other connections other than the front struts...
I used the Arnott's to do my rear. Still trying to sort out the front. But I am about to replace the front hub bearing, pads and rotors and axleshafts. may as well do these as well.
One of the front wheel bearings is howling. So I am going to replace both bearings, the front pads, and rotors. I am wanting to replace the half shafts while I am there as well. The boots look worn but nothing is wrong with them. But my Denali has almost 180k miles so I figured why not go ahead...
I assume the springs are ok. I could rebuild them sure. but was hoping to be able to replace everything. Then again I may not have a choice. Are the rock auto units good quality tho?
it seems there is a huge gap in pricing for the front shocks. I have looked on O'Reilly and Autozone and they are wanting $500 and up each. I looked on RockAuto and there are some that are half that proce. Yet I question if it is a quality unit.
my truck has 175K miles, so I am wanting to...
So I replaced my air compressor and both rear shocks. Slightly compressed axle and turned key on to allow shocks to fill up.
When that happened. Service stabilitrak and service traction control message showed on D.I.C.
Put tires on, let it down on the ground. Now I have same messages. And...
Come to find out the motor is fine. The gears are stripped out. I ordered parts, and manually moved the seat back. Took a 5/16 socket and hammered it on to the end of the screw. And just turned each one til I got the seat to where I want it.
Wife sat in the seat for the first time yesterday...
I was looking around on the inner webs and have found where it says that the L92 does not have AFM(DOD) but does have VVT. But have seen other sources say that there is no VVT either. It was my understanding that VVT didnt hit the 6.2L engine until 2009 when the AFM also was added to the...
Oh I may go to 4.10’s then. And you don’t buy a Denali because you wanna conserve gas. At least I didn’t.
I used to have a ‘13 SS Camaro, bought it new. 2yrs later was stolen. Life has happened. And I’m in a spot where I need to haul 4 English mastiffs. So I have a Denali. And I can build it...
I have tossed around the idea of 4.10’s but have concerns about highway rpm’s at 70-75
The plan would be to put all new gears and bearing in the axles. Won’t be any different than doing it on a 4x4 I have done a lot.
i was curious if anyone has upgraded their axle ratios to 3.73's? I have a 07 Denali, im wanting some more grunt off the line. was curious if anyone else has done this. and what the highway manners were?
I will look in to it. I am also looking in to the Texas Speed and Performance longtubes, my plan is to build this close to a '13 Camaro SS I used to have. So headers, cam, heads are all in the works . But also have concerns if the trans cant take the increased HP. I have read the 6L80E is good...
has anyone used these? ease of installation? obviously will need to have them coated or painted with high temp paint or something. but they seem affordable. I am going to be installing some bolt-ons. Was curious if these are even worth considering.
https://www.summitracing.com/parts/psm-70-2269
Starter was dead.
I mean it ran when parked. LoL
New starter, battery and positive cable.
Thanks for the help everyone.
I’m Still floored the starter just died like that.
Cleaned the connections on the mega fuse when I replaced the battery. But didn’t crawl under the truck and look. When I did just look under. Saw your typical blue green corrosion on the wire that was exposed.
So I’ve had my Denali almost a month. It was parked for a few days while I enjoyed my days off.
Get in it to go to work and nothing. Had battery tested. It was bad. Put a new battery in it. No change. Turn the key and nothing.
No click or even an attempt at starter engagement.
Going to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.