Search results

  1. ratled

    Audio guys '02 subwoofer

    Thanks but I don't trust them as they are recommending 4 ohm spears to replace a 2 ohm speaker. I was told I would need an amp to power them
  2. ratled

    Audio guys '02 subwoofer

    '02 GMC Yukon (short) non Bose with on star 8" subwoofer question - I'm not an audio guy, have bad ears so a stock system is more than fine. Looking at this for a direct replacement. Open to suggestions Thanks...
  3. ratled

    Bolts size for wiper fluid tank

    Found it listed as M6-1.0 x 25mm
  4. ratled

    Bolts size for wiper fluid tank

    Went to replace my battery and saw my wiper fluid tank was held in only with zip ties! Both bolts are missing. Any idea what size these are? Thanks ratled
  5. ratled

    P0402 code

    Started throwing a P0402 code yesterday. From what I'm seeing its EGR related. Any pointer to narrow it down? 2002 5.3 gaser with 160,000 on it. I did the O2 sensors at about 100k. Not losing power, no performance issues noted and not making any unusual sounds Thanks Ratled
  6. ratled

    Anyone replace the window felt & door jam rubber?

    The window on one of my rigs the felt is need of reconditioning or replacing and the other has a door jam rubber that is the same. The felt has a ton of grit in it and is scratching the glass. I have buffed it out nicely but it comes back fairly quickly so its time to fix the issue not the...
  7. ratled

    Tablet/ipad

    Sorry I sold the Jeep for the Yukon. But here is a pic to give you and idea - except for a camera you mount the ipd and mount. Clamp it in the handle just above the golvebox. Best of all you can take it off when not in use
  8. ratled

    Tablet/ipad

    You could run a setup off the passenger grab handle. This is what I used on my Jeep I Pad gen 4 Ram Mounts RAP –B-404u - Medium Tough Claw RAM-B-202U 3” arm 4/ round base RAM-HOL- TAB20U – 8” I pad holder RAM-HOL-UN8TU -Webbing
  9. ratled

    Code P0102 MAF won't go away

    @Mass - nope, just using the local parts places' one
  10. ratled

    Code P0102 MAF won't go away

    For my 2002 GMC Yukon 5.3 gas, 4wd The check engine light started coming on intermittently - code P0102. I cleaned the MAF with MAF spray, the air filter is new and the light went away. Then it started again. I cleaned everything again it went away for a few days and returned. After a few...
  11. ratled

    7 pin plug wire color codes?

    Thanks SD
  12. ratled

    7 pin plug wire color codes?

    I have new trailer with a 4 pin setup and I want to run it off either my truck (4 pin) or the Yukon (7pin). I'll just tap a 4 pin into the GMC to have both on it. I have heard conflicting info on what color wire serves which function on the GMC. Can anyone confirm the colors on the stock 7...
  13. ratled

    What did you do to your NBS GMT800 Tahoe/Yukon Today?

    Did the ABS and the P Brake light come on?
  14. ratled

    Chugging or miss fire

    Try this https://www.tahoeyukonforum.com/threads/real-rough-idle-at-start.133875/#post-1672830
  15. ratled

    What did you do to your NBS GMT800 Tahoe/Yukon Today?

    death wobble, its not just for Jeeps! OK, may not be but sounds familiar..... #1 cause of DW is tire balance
  16. ratled

    The ABS and the P Brake light keep coming on

    2002 2wd with a 5.3 and about 157,000 on it. The ABS and the P Brake light comes on about every other trip, light up about 5 -10 minutes into the drive and stay on until the key is turned off. I was just driving down the freeway for about an hour the first time it happened. No changes in...
  17. ratled

    Yukon stored for 10 years. How to bring back to life?

    get some oil on those rings (Marvel Mystery Oil inside the cylinder) before turning it over & drain fuel for openers
  18. ratled

    Round 2

    If you are taking about the metor, and you go back, take a stick with a magnet on the end and see what you can find. At $3 -$100 a gram you can do well
  19. ratled

    What did you do to your NBS GMT800 Tahoe/Yukon Today?

    Runs like a champ! It wasn't running bad before the sudden rough start up but I can tell after the fact it wasn't running top notch and can notice the difference now.
  20. ratled

    What did you do to your NBS GMT800 Tahoe/Yukon Today?

    Changed out my O2 sensors. Thanks to Doubleive for responding to My Post on a real rough start up. I can't believe (no pun intended) I forgot all about those, I didn't even have it on my new to me/100k service. Bank 1 upstream was a real PITA but the rest were a breeze ratled
  21. ratled

    Real rough idle at start

    Just a quick update - So the O2 sensors are the original ones. Whether they are my issue or not they need to be replaced (though I think this is my current issue). Just wondering if I HAVE To have a O2 sensor wrench or can I get by with a regular wrench to break them free Thanks ratled
  22. ratled

    Real rough idle at start

    I forgot about the O2 sensors in the 110-120 range. Everything else is squared away
  23. ratled

    Real rough idle at start

    Just looking for first thoughts on this one. 02 GMC 5.3 gas with about 120k on it. Has been running like a top and the only thing of note is the change oil light came on 2 days ago. Went to start it yesterday and it had a real rough idle. It kicked itself to about 1500 rpms and smoothed...
  24. ratled

    What did you do to your NBS GMT800 Tahoe/Yukon Today?

    Try running the VIN through HERE it may tell you... at least it's free
  25. ratled

    Tires

    Cooper AT3 S

Forum statistics

Threads
138,086
Posts
1,998,558
Members
103,011
Latest member
Dh1280

Latest posts

Back
Top