Search results

  1. kbuskill

    Kbuskill's 2008 Burb LTZ "MOD" Thread

    Just some good stainless worm gear clamps.
  2. kbuskill

    Kbuskill's 2008 Burb LTZ "MOD" Thread

    You probably could but there isn't a ton of room to work as the metal lines run on top of the frame rail and only stick out a little bit from the frame. When you cut the crimps off there is a metal ridge that acts kind of like a barb so I put a hose clamp on both sides of the ridge and have...
  3. kbuskill

    Kbuskill's 2008 Burb LTZ "MOD" Thread

    Forgot to post this when we did it a while back. I replaced the rear sections of rubber hose going to the rear heater core as well as the plastic quick connect fittings at rear heater core. I don't trust the plastic quick connects so I found some metal ones to replace them. I used a Fordham...
  4. kbuskill

    Want to take my 2010 Yukon XL Denali with 180,000 miles for a family trip from Michigan To Florida

    No, it is just an inspection plug. You can pop it out with your pocket knife or a small screwdriver and look up into the bellhousing with a flash light or inspection camera if you have one. You won't be able to see a ton as it isn't like the older transmissions where you could remove the...
  5. kbuskill

    Want to take my 2010 Yukon XL Denali with 180,000 miles for a family trip from Michigan To Florida

    Could be either or it could be oil filter leaking and blowing back or oil cooler lines/block off plate leaking and blowing back.
  6. kbuskill

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    My SKF Xtracker hubs lasted almost 5 years before starting to make noise. I had them replaced through Rock Auto just before the 5 yr warranty ran out. If these somehow manage to make it past the 5yr warranty this time then I will probably go back to GM OEM hubs when they finally crap the bed.
  7. kbuskill

    What to use to plug oil pan relief?

    https://a.co/d/gLD9saR For a VW but fits the pressure relief valve inside the LS oil pan.
  8. kbuskill

    Kbuskill's 2008 Burb LTZ "MOD" Thread

    Latest Blackstone report. I believe they misspoke when they said "copper" and actually meant lead. The lead was high for a while due to what I believe was lead leaching out of the Chinese aftermarket oil cooler I installed. I think it has finally cleared up after all this time. Either way all...
  9. kbuskill

    Air Lift 1000 Helper Springs with OE compressor, etc.

    They are shorter, I'm not sure of the exact difference, but combine that with the extra weight of a Tahoe/Suburban and it means the Trailblazer bags ride really good at around a 4" drop from stock on the full size trucks. You can go lower and it will feel soft and squishy or higher and it will...
  10. kbuskill

    Air Lift 1000 Helper Springs with OE compressor, etc.

    The Trailblazer bags are compatible and will work beautifully with the factory compressor. The catch is, unless you are looking for a 4" drop in the rear, the ride is probably going to be very stiff. Although I suppose you could run a spacer under the bag to compensate for the height needed. I...
  11. kbuskill

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    12.2V is already low for resting voltage. 12.8V is where it should be.
  12. kbuskill

    Kbuskill's 2008 Burb LTZ "MOD" Thread

    Kinda, I made my own with a Relay+Capacitor+Diode. It takes approximately 2 seconds for the Cap to drain and turn off the cornering light after shutting off the turn signal. The power from the signal charges the cap and keeps the light on continously while the turn signal is off, and by the...
  13. kbuskill

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    What did you do to your NNBS GMT900 Tahoe/Yukon Today? Well, I'm glad you asked... lol https://www.tahoeyukonforum.com/threads/kbuskills-2008-burb-ltz-mod-thread.100141/post-2014092
  14. kbuskill

    Kbuskill's 2008 Burb LTZ "MOD" Thread

    Added cornering lights to the Burb to assist with dark roads/driveways at night. I really like them. I will get some more photos in the daylight. Also added these...
  15. kbuskill

    Door TRIM part 22874309

    Salvage yard may be your best bet.
  16. kbuskill

    GeorgeB’s 2013 Suburban LTZ “Fin”

    Yeah, I should have been more clear in my post, I was referring to both the M/S and M/S2 when I said they are rated at 70k miles. I can understand the whole winter aspect. I don't seem to have that issue down here in the free state of Florida for some reason... lol
  17. kbuskill

    GeorgeB’s 2013 Suburban LTZ “Fin”

    I just put them on my Burb about 6k miles ago. So far so good. I got about 78k miles out of the last LTX M/S I had on there. They are rated at 70k miles.
  18. kbuskill

    Useless Information

    I Hope and Pray everything is ok.
  19. kbuskill

    4.10 vs 4.56

    It would seem James @swathdiver has a spreadsheet for everything... lol
  20. kbuskill

    Fosscore's 2013 Suburban LTZ Build Thread

    I've always been a 1st gen (Squarebody) S-10 guy, especially the 2 door Blazers. I have also owned a couple Nissan Hardbodys through the years. Those trucks definitely bring back memories of the good ol' days.
  21. kbuskill

    Kbuskill's 2008 Burb LTZ "MOD" Thread

    Do you think they will sing "Fa ra ra ra ra, Ra ra ra ra" to us like in the movie A Christmas Story?... lol
  22. kbuskill

    Kbuskill's 2008 Burb LTZ "MOD" Thread

    I love onion rings, onions in general actually. Every year for the past several years my son and I go to the mini truck nationals in NC and on the way home I stop in Vidalia, GA. and buy 100+ lbs of sweet Vidalia onions because the truck show is usually around the same time as the Vidalia onion...
  23. kbuskill

    Kbuskill's 2008 Burb LTZ "MOD" Thread

    Something like that... lol FL to Grand Canyon > Monument Valley > scenic route to Cedar City, UT. > Grand staircase Escalante > Moab, UT. > Boulder, CO. Which will be home base for about 5 days while we go on day trips to Rocky Mountain NP, WY, Colorado Springs to ride the Cog train to the top...
  24. kbuskill

    Kbuskill's 2008 Burb LTZ "MOD" Thread

    Just getting some last minute preventative maintenance out of the way before a BIG trip planned for the family at the end of the year. Will end up being 6k-7k miles round trip when all is said and done.
  25. kbuskill

    Kbuskill's 2008 Burb LTZ "MOD" Thread

    That is why I think it may be year specific as my 2008 is an LTZ but didn't come with these, and these were removed from a 2011 I believe.

Forum statistics

Threads
138,037
Posts
1,997,574
Members
102,974
Latest member
kikeap

Latest posts

Back
Top